No abstract

To mitigate the diesel particle pollution problem, diesel vehicles are fitted with modern exhaust after-treatment systems (ATS), which efficiently remove engine-generated primary particles (soot and ash) and gaseous hydrocarbons. Unfortunately, ATS can promote formation of low-vapor-pressure gases, which may undergo nucleation and condensation leading to formation of nucleation particles (NUP). The chemical nature and formation mechanism of these particles are only poorly explored. Using a novel mass spectrometric method, online measurements of low-vapor-pressure gases were performed for exhaust of a modern heavy-duty diesel engine operated with modern ATS and combusting low and ultralow sulfur fuels and also biofuel. It was observed that the gaseous sulfuric acid (GSA) concentration varied strongly, although engine operation was stable. However, the exhaust GSA was observed to be affected by fuel sulfur level, exhaust after-treatment, and driving conditions. Significant GSA concentrations were measured also when biofuel was used, indicating that GSA can be originated also from lubricant oil sulfur. Furthermore, accompanying NUP measurements and NUP model simulations were performed. We found that the exhaust GSA promotes NUP formation, but also organic (acidic) precursor gases can have a role. The model results indicate that that the measured GSA concentration alone is not high enough to grow the particles to the detected sizes.

We have studied the effect of three different fuels (fossil diesel fuel (EN590); rapeseed methyl ester (RME); and synthetic gas-to-liquid (GTL)) on heavy-duty diesel engine emissions. Our main focus was on nanoparticle emissions of the engine. Our results show that the particle emissions from a modern diesel engine run with EN590, GTL, or RME consisted of two partly nonvolatile modes that were clearly separated in particle size. The concentration and geometric mean diameter of nonvolatile nucleation mode cores measured with RME were substantially greater than with the other fuels. The soot particle concentration and soot particle size were lowest with RME. With EN590 and GTL, a similar engine load dependence of the nonvolatile nucleation mode particle size and concentration imply a similar formation mechanism of the particles. For RME, the nonvolatile core particle size was larger and the concentration dependence on engine load was clearly different from that of EN590 and GTL. This indicates that the formation mechanism of the core particles is different for RME. This can be explained by differences in the fuel characteristics.

Particle emissions of modern diesel engines are of a particular interest because of their negative health effects. The special interest is in nanosized solid particles. The effect of an open channel filter on particle emissions of a modern heavy-duty diesel engine (MAN D2066 LF31, model year 2006) was studied. Here, the authors show that the open channel filter made from metal screen efficiently reduced the number of the smallest particles and, notably, the number and mass concentration of soot particles. The filter used in this study reached 78% particle mass reduction over the European Steady Cycle. Considering the size-segregated number concentration reduction, the collection efficiency was over 95% for particles smaller than 10 nm. The diffusion is the dominant collection mechanism in small particle sizes, thus the collection efficiency decreased as particle size increased, attaining 50% at 100 nm. The overall particle number reduction was 66 -99%, and for accumulation-mode particles the number concentration reduction was 62-69%, both depending on the engine load.