Forty-three Spanish populations of hairy fleabane, sampled from perennial crop locations, were studied under controlled and field conditions to confirm and characterize glyphosate resistance. In the initial screening, under controlled conditions, significant differences in glyphosate response between locations and among plant progenies within location were observed. From the initial screening, six populations (five potentially resistant [R] and one susceptible [S]) were selected, and a dose–response experiment was conducted to determine the resistance factor. The resistance factor was close to 10× for the most resistant population. In addition, the glyphosate response of R and S populations was dependant on phenological stages: the glyphosate rate required for control increased as a function of plant age. Finally, the resistance was confirmed with field trials conducted in five locations (one S and four R previously studied under controlled conditions). The field trials were also used to find alternative solutions for Spanish farmers to control resistant hairy fleabane populations.

No abstract

SUMMARY This work is part of the research project known as Efficacia: Reduction of energy consumption and environmental impact of the construction of subsidised housing inPalabras clave: Monitorización, demanda energética, eficiencia energética, ahorro energético, viviendas protegidas.

The influence of pre-fermentative maceration and ageing factors on the ester profiles of Pedro Ximenez sparkling wines was evaluated. The pre-fermentative maceration consisted of the skin-maceration of musts at 10°C for 6h. The sparkling wines were produced following the Champenoise method. Samples were monitored at 3, 6 and 9months of ageing on lees. Sparkling wines with pre-fermentative maceration displayed higher contents of ethyl esters of branched acids and cinnamates. Meanwhile, those without maceration showed higher levels of ethyl esters of fatty acids and higher alcohol acetates. The study of statistical interactions elucidated different hydrolytic kinetics and developments in higher alcohol acetates and ethyl esters of branched acids during ageing. The application of a dual criterion based on univariate (ANOVA) and multivariate analyses (OPLS-DA) allowed us to identify new potential volatile markers related to pre-fermentative maceration and ageing time, reported for the first time in sparkling wines.

Polymer flooding has gained much interest within the oil industry in the past few decades as one of the most successful chemical enhanced oil recovery (CEOR) methods. The injectivity of polymer solutions in porous media is a key factor in polymer flooding projects. The main challenge that faces prediction of polymer injectivity in field applications is the inherent non-Newtonian behavior of polymer solutions. Polymer in situ rheology in porous media may exhibit complex behavior that encompasses shear thickening at high flow rates in addition to the typical shear thinning at low rates. This shear-dependent behavior is usually measured in lab core flood experiments. However, data from field applications are usually limited to the well bottom-hole pressure (BHP) as the sole source of information. In this paper, we analyze BHP data from field polymer injectivity test conducted in a Middle Eastern heterogeneous carbonate reservoir characterized by high-temperature and high-salinity (HTHS) conditions. The analysis involved incorporating available data to build a single-well model to simulate the injectivity test. Several generic sensitivities were tested to investigate the impact of stepwise variation in injection flow rate and polymer concentration. Polymer injection was reflected in a non-linear increase in pressure with injection, and longer transient behavior toward steady state. The results differ from water injection which have linear pressure response to rate variation, and quick stabilization of pressure after rate change. The best match of the polymer injection was obtained with complex rheology, that means the combined shear thickening at high rate near the well and moving through apparent Newtonian and shear thinning at low rate.