SummaryOxybenzone (Benzophenone-3) is an emerging human and environmental contaminant used in sunscreens and personal care products to help minimize the damaging effects of ultraviolet radiation. The Center for Disease Control fourth national report on human exposure to environmental chemicals demonstrated that approximately 97% of the people tested have oxybenzone present in their urine, and independent scientists have reported various concentrations in waterways and fish worldwide. Oxybenzone can also react with chlorine, producing hazardous by-products that can concentrate in swimming pools and wastewater treatment plants.Moreover, adverse reactions could very well be increased by the closed loop of ingesting fish contaminated with oxybenzone and/or washing the ingredient off our bodies and having it return in drinking water as treatment plants do not effectively remove the chemical as part of their processing protocols. In humans, oxybenzone has been reported to produce contact and photocontact allergy reactions, implemented as a possible endocrine disruptor and has been linked to Hirschsprung's disease. Environmentally, oxybenzone has been shown to produce a variety of toxic reactions in coral and fish ranging from reef bleaching to mortality. Lastly, with the rise in skin cancer rates and the availability of more effective sunscreen actives such as micronized zinc oxide and titanium dioxide, serious doubts about the relative prevention benefit of personal care products containing oxybenzone must be raised and compared with the potential negative health and environmental effects caused by the accumulation of this and other chemicals in the ecosystem.

When UVB-burned skin was treated with glycolic acid daily for 7 days (site 2), a 16% reduction in irritation was observed compared to nontreated skin (site 1), implying that skin healed sooner when treated with glycolic acid. When a comparison of nontreated skin was made to skin treated with glycolic acid for 3 weeks prior to UVB exposure (site 1 vs site 3), a sun protection factor (SPF) of 2.4 was achieved. When a comparison of skin treated for 3 weeks was made to skin treated for 3 weeks and chemically peeled (site 3 vs site 4) the data implied that the chemical peel reduced the SPF value of skin treated with glycolic by approximately 50%, however, an SPF trend of 1.7 was still obtained when compared with untreated skin. CONCLUSIONS. The studies demonstrated that topical glycolic acid provides a photoprotective effect to pretreated skin yielding an SPF of approximately 2.4. In addition, when glycolic acid is applied to irradiated skin, it accelerates resolution of erythema. The data obtained from both studies support the hypothesis that glycolic acids acts as an antioxidant.

Benzophenone is a mutagen, carcinogen, and endocrine disruptor. Its presence in food products or food packaging is banned in the United States. Under California Proposition 65, there is no safe harbor for benzophenone in any personal care products, including sunscreens, anti-aging creams, and moisturizers. The purpose of this study was to determine (1) if benzophenone was present in a wide variety of commercial sun protection factor (SPF)/sunscreen products, (2) whether benzophenone concentration in the product increased over time, and (3) if the degradation of octocrylene was the likely source for benzophenone contamination. Benzophenone concentration was assayed in nine commercial sunscreen products from the European Union and eight from the United States (in triplicate), including two single ingredient sources of octocrylene. These same SPF items were subjected to the United States Food and Drug Administration (U.S. FDA)-accelerated stability aging protocol for 6 weeks. Benzophenone was measured in the accelerated-aged products. Sixteen octocrylene-containing product lines that were recently purchased had an average concentration of 39 mg/kg benzophenone, ranging from 6 mg/kg to 186 mg/kg. Benzophenone was not detectable in the product that did not contain octocrylene. After subjecting the 17 products to the U.S. FDA-accelerated stability method, the 16 octocrylene-containing products had an average concentration of 75 mg/kg, ranging from 9.8 mg/kg to 435 mg/kg. Benzophenone was not detectable in the product that did not contain octocrylene. Benzophenone was detected in the pure octocrylene manufactured ingredient. Octocrylene generates benzophenone through a retro-aldol condensation. In vivo, up to 70% of the benzophenone in these sunscreen products may be absorbed through the skin. U.S. FDA has established a zero tolerance for benzophenone as a food additive. In the United States, there were 2999 SPF products containing octocrylene in 2019. The safety of octocrylene as a benzophenone generator in SPF or any consumer products should be expeditiously reviewed by regulatory agencies.

All pH levels and concentrations demonstrated significant improvement in the condition of the skin with trends implying that increasing the pH increases efficacy.