The adsorption of anionic phospholipids on silica was investigated by the dissipative quartz crystal microbalance (QCM) technique. Liposomes composed of 1 mM 80:20 mol % of 1-palmitoyl-2-oleyl-sn-glycero-3-phosphatidylcholine (POPC)/phosphatidic acid, POPC/phosphatidylglycerol, or POPC/phosphatidylserine in N-(2-hydroxyethyl)piperazine-N'-(2-ethanesulfonic acid) buffer at pH 7.4 (with or without 3 mM of CaCl2) were examined. We have previously demonstrated that similar phospholipid coatings can be used in capillary electrochromatography as a stationary phase for the separation of analytes. In this work, we focus on the formation of the coatings and on the type of lipid structure formed on silica. The QCM investigation comprised qualitative results based on changes in frequency and resistance, and quantitative modeling of the obtained results. The latter was performed using the dissipative QCM, which measures the quartz crystal impedance, combined with equivalent circuit analysis. A previously developed coating and cleaning procedure for phospholipid-coated fused silica capillaries was adopted in this study, and the same silica-coated crystal was used throughout the QCM study. We will demonstrate in this work that the type of lipid structure formed on silica, that is, a rather rigid supported lipid bilayer or a viscoelastic supported vesicle layer (SVL), is highly dependent on the lipid and solvent composition. We also show for the first time that the modeling of the dissipative QCM data can be used to extract a more quantitative picture of an adsorbed SVL, because, so far, published studies have merely used the QCM data in a qualitative sense.

Recently, tethered bilayer lipid membranes (tBLMs) have shown high potential as biomimetic systems due to their high stability and electrical properties, and have been used in applications ranging from membrane protein incorporation to biosensors. However, the kinetics of their formation remains largely uninvestigated. By using quartz crystal microbalance with impedance analysis (QCM-Z), we were able to monitor both the kinetics and viscoelastic properties of tether adsorption and vesicle fusion. Formation of the tether monolayer was shown to follow pseudo-first-order Langmuir kinetics with association and dissociation rate constants of 21.7 M-1 s(-1) and 7.43 x 10-6 s(-1), respectively. Moreover, the QCM-Z results indicate a rigid layer at the height of deposition, which then undergoes swelling as indicated by AFM. The deposition of vesicles to the tether layer also followed pseudo-first-order Langmuir kinetics with observed rate constants of 5.58 x 10(-2) and 2.41 x 10-2 s(-1) in water and buffer, respectively. Differential analysis of the QCM-Z data indicated deposition to be the fast kinetic step, with the rate-limiting steps being water release and fusion. Atomic force microscopy pictures taken complement the QCM-Z data, showing the major stages of tether adsorption and vesicle fusion, while providing a road map to successful tBLM formation.

Phase separation in mixed monolayers of phosphatidylcholine (PC) and pyrene-labeled phosphatidic acid (PA) was observed by fluorescence microscopy on an air/water interface as a function of subphase Ca2+ concentration and lateral packing pressure of the film. Below 45 mN m-1 and in the absence of Ca2+ no indications of phase immiscibility were observed. Addition of 1 mM Ca2+ caused extensive phase separation, which was evident immediately after spreading of the film. Further increase in Ca2+ concentration up to 30 mM increased the pyrene excimer intensity of the separated phosphatidic acid enriched domains. In the presence of Ca2+ (1-30 mM) and at surface pressures below 10 mN m-1 phase separation was always evident. However, as surface pressure exceeded 10 mN m-1, mixing of PC and PA occurred. Upon decompression of the film, phase separation reappeared at surface pressures close to 10 mN m-1. The surface textures of the film before and after the compression and subsequent relaxation were different. Inclusion of 30 mol% cholesterol increased the number and decreased the size of the PA domains. In films containing 50 mol% cholesterol no phase separation could be detected at the resolution available.

No abstract