In the sector of occupational safety and health only a limited amount of studies are concerned with the conversion of inhalable to respirable dust. This conversion is of high importance for retrospective evaluations of exposure levels or of occupational diseases. For this reason a possibility to convert inhalable into respirable dust is discussed in this study. To determine conversion functions from inhalable to respirable dust fractions, 15 120 parallel measurements in the exposure database MEGA (maintained at the Institute for Occupational Safety and Health of the German Social Accident Insurance) are investigated by regression analysis. For this purpose, the whole data set is split into the influencing factors working activity and material. Inhalable dust is the most important predictor variable and shows an adjusted coefficient of determination of 0.585 (R2 adjusted to sample size). Further improvement of the model is gained, when the data set is split into six working activities and three material groups (e.g. high temperature processing, adj. R2 = 0.668). The combination of these two variables leads to a group of data concerned with high temperature processing with metal, which gives rise to a better description than the whole data set (adj. R2 = 0.706). Although it is not possible to refine these groups further systematically, seven improved groups are formed by trial and error, with adj. R2 between 0.733 and 0.835: soldering, casting (metalworking), welding, high temperature cutting, blasting, chiseling/embossing, and wire drawing. The conversion functions for the seven groups are appropriate candidates for data reconstruction and retrospective exposure assessment. However, this is restricted to a careful analysis of the working conditions. All conversion functions are power functions with exponents between 0.454 and 0.946. Thus, the present data do not support the assumption that respirable and inhalable dust are linearly correlated in general.

The drivers of ten vehicles (tram, helicopter, saloon car, van, forklift, two mobile excavators, wheel loader, tractor, elevating platform truck) were studied with regard to the combined exposures of whole-body vibration and awkward posture during occupational tasks. Seven degrees of freedom (DOFs), or body angles, were recorded as a function of time by means of the CUELA measuring system (Computer-assisted registration and long-term analysis of musculoskeletal workloads) for the purpose of posture assessment. The vibrational exposure is expressed as the vector sum of the frequency-weighted accelerations in the three Cartesian coordinates; these were recorded simultaneously with the posture measurement. Based upon the percentage of working time spent under different workloads, a scheme is proposed for classification of the two exposures into three categories. In addition, a risk of adverse health effects classified as low, possible or high can be assigned to the combination of the two exposures. With regard to posture, the most severe exposure was measured for the drivers of the wheel loader and for the tractor driver, whereas the lowest exposure was measured for the helicopter pilots and van drivers. With regard to the combination of whole-body and posture exposures, the tractor driver and the elevating platform truck driver exhibited the highest workloads.

The combined exposure of WBV and awkward posture can be described in terms of the daily vibration exposure and the index for awkward posture. This facilitates work place assessments and future research in this area. Practitioner Summary: For the first time, quantitative measures combining whole-body vibration and awkward posture exposures have shown to correlate with the occurrence of low back pain significantly. This validates the proposed quantities and measurement methods, which facilitate workplace assessments and assist in the design of further studies which are necessary to establish a causal exposure-response relationship.

No abstract

Latest developments in international standardization of whole-body and hand-arm vibration are presented. In addition, two German projects are presented that might have impact on international work programs in the next years.