No abstract

Tuning the electronic band structures such as band-edge position and bandgap of organic semiconductors is crucial to maximize the performance of organic photovoltaic devices. We present a simple yet effective electron irradiation approach to tune the band structure of [6, 6]-phenyl-C61-butyric acid methyl ester (PCBM) that is the most widely used organic acceptor material. We have found that the lowest unoccupied molecular orbital (LUMO) level of PCBM up-shifts toward the vacuum energy level, while the highest occupied molecular orbital (HOMO) level down-shifts when PCBM is electron-irradiated. The shift of the HOMO and the LUMO levels increases as the irradiated electron fluence increases. Accordingly, the band-edge position and the bandgap of PCBM can be controlled by adjusting the electron fluence. Characterization of electron-irradiated PCBM reveals that the variation of the band structure is attributed to the molecular structural change of PCBM by electron irradiation.

We present a novel method to fabricate complete and highly oriented anodic titanium oxide (ATO) nano-porous structures with uniform and parallel nanochannels. ATO nano-porous structures are fabricated by anodizing a Ti-foil in two different organic viscous electrolytes at room temperature using a two-step anodizing method. TiO2 nanotubes covered with a few nanometer thin nano-porous layer is produced when the first and the second anodization are carried out in the same electrolyte. However, a complete titania nano-porous (TNP) structures are obtained when the second anodization is conducted in a viscous electrolyte when compared to the first one. TNP structure was attributed to the suppression of F-rich layer dissolution between the cell boundaries in the viscous electrolyte. The structural morphologies were examined by field emission scanning electron microscope. The average pore diameter is approximately 70 nm, while the average inter-pore distance is approximately 130 nm. These TNP structures are useful to fabricate other nanostructure materials and nanodevices.

No abstract

We present a novel and straightforward approach to fabricate large-scale and robust free-standing TiO(2) nanotube (TNT) membranes. Simply by blowing N(2) gas onto as-anodized TNTs that are wetted with methanol, free-standing TNT membranes are produced. The approach also provides homogeneous and honeycomb-like Ti substrates after the detachment of TNT membranes. Through the second anodization of the honeycomb-like Ti substrates following the N(2) blowing, TNT membranes comprising hexagonally close-packed and regularly ordered TNTs with clear open ends can be achieved. Characterization of the free-standing TNT membranes using Raman spectroscopy and a high-resolution transmission electron microscope reveals that anatase TiO(2) and crystalline graphitic carbon are embedded in the bottom surface of the free-standing TNT membranes.