No abstract

No abstract

Bone mineral density (BMD) is a predictor of fracture risk. The purpose of this study was to determine whether a correlation exists between femoral neck BMD and an indicator of mechanical bone strength in human and bovine samples. Human proximal femurs were obtained from seven men and two women undergoing total hip arthroplasty (THA), mean age 60.3 years. Preoperative BMD measurements of the femoral neck were obtained (Lunar DPX). A 3 cm2 area of interest on each excised femoral neck corresponding to the preoperative BMD measurement site was carefully marked and BMD was remeasured postoperatively. Ten excised bovine femoral necks were also measured for BMD. A bicortical core, each cortex 2.8 cm2 in area, containing the center of the area of interest was removed from the human and bovine femoral necks, cut into multiple 7-mm thick, multiple cross-sectional discs, and measured for hardness by indent depth (Rockwell International Hardness Tester, Wilson Mechanical Instruments, New York, NY). In vivo human femoral neck BMD measurements correlated with in vitro BMD measurements (r = 0.99). BMD measurements of human femoral necks were significantly lower than BMD measurements of bovine femoral necks (P < 0.05). Inverse relationships were found between in vivo and in vitro human BMD measurements and indent depth (r = -0.58 and -0.59, respectively). Bovine BMD measurements and indent depth were also inversely related (r = -0.64).(ABSTRACT TRUNCATED AT 250 WORDS)

Broadband ultrasound attenuation (BUA) of the calcaneus has been found to correlate with bone mineral density (BMD) of the femoral neck. The purpose of this study was to determine if a correlation exists among femoral neck BUA, femoral neck BMD, and incremental indent depth, a qualitative indicator of local mechanical bone strength, in bovine samples, and if this correlation is dependent upon orientation. For 12 of the bovine samples obtained, BUA was measured at the femoral neck and was followed by a BMD determination of the same area. A 19 mm diameter bicortical core containing the center of the area of interest was removed, transversely cut into 7 mm, thick disks, and tested for hardness by indent depth. For these tests, BMD was well correlated with BUA (R2 = 0.85, P < 0.001). An inversely proportional relationship with a modest correlation was found between indent depth and BMD (R2 = 0.59, P = 0.026), and indent depth and BUA (R2 = 0.57, P = 0.031). In a second set of tests involving 15 different bovine samples, a bicortical core was removed from the femoral neck. A trabecular bone cube measuring 1.5 cm on a side was removed from the center of the core. BUA and BMD measurements were made along the anterior-posterior (AP), medial-lateral (ML), and cephalic-caudal (CC) aspects of the cube. The cubes were randomly separated into three groups, cut in half perpendicular to the axis of interest, and tested for hardness by indent depth. In these tests, no significant difference was found in BMD among the three orientations of the cubes scanned (P = 0.77). In contrast, the BUA along the ML orientation of the cube was significantly greater than that along the AP orientation (P < 0.05). No significant difference was found in the incremental indent depth measurements among cube orientations (P = 0.41). In the test involving only trabecular bone, a much higher correlation between BMD and incremental indent depth was found regardless of cube orientation (R2 = 0.64, P < 0.001). The data indicate that BUA, but not BMD, is affected by trabecular orientation, and that BMD is negatively correlated with incremental indent depth.

No abstract