The Cenozoic history of the retreating Hellenic subduction system in the eastern Mediterranean involves subduction, accretion, arc magmatism, exhumation, normal faulting, and large-scale continental extension from ∼60 Mya until the Recent. Ages for high-pressure metamorphism in the central Aegean Sea region range from ∼53 Ma in the north (the Cyclades islands) to ∼25−20 Ma in the south (Crete). Younging of high-pressure metamorphism reflects the southward retreat of the Hellenic subduction zone. The shape of pressure-temperature-time paths of high-pressure rocks is remarkably similar across all tectonic units, suggesting a steady-state thermal profile of the subduction system and persistence of deformation and exhumation styles. The high-pressure metamorphic events were caused by the underthrusting of fragments of continental crust that were superimposed on slab retreat. Most of the exhumation of high-pressure units occurred in extrusion wedges during ongoing lithospheric convergence. At 23–19 Mya large-scale lithospheric extension commenced, causing metamorphic core complexes and the opening of the Aegean Sea basin. This extensional stage caused limited exhumation at the margins of the Aegean Sea but accomplished the major part of the exhumation of high-grade rocks that formed between 21 and 16 Mya in the central Aegean. The age pattern of extensional faults and contoured maps of fission-track cooling ages do not show a simple southward progression. Our review of lithologic, structural, metamorphic, and geochronologic data is consistent with a temporal link between the draping of the subducted slab over the 660-km discontinuity and the large-scale extension causing the opening of the Aegean Sea basin.

We present a quantitative reconstruction of uplift of the western flank of the Altiplano plateau (central Andes), one of the largest monoclines on the Earth, on the basis of an analysis of tectonic structures, syntectonic deposits, and geophysical data. Uplift occurred on a west vergent, slowly propagating system of high‐angle reverse faults merging into a joint detachment that ramps down to midcrustal levels below the plateau edge. The upper ramps determine local fold geometries while the lower ramp controls large‐scale surface tilting and uplift. At 20°S, this fault system was active between ∼30 Ma and 5–10 Ma, with maximum shortening rates of 0.22 mm/yr between 17 and 10 Ma. It generated some 2600 m of surface uplift with only minor shortening of ∼3000 m. Its activity was largely synchronous to eruption of large‐volume ignimbrites from a midcrustal source. Geophysical data indicate that the fault system localized deformation at the boundary between a cool, strong forearc crust and a presumably fluid‐rich and/or partially molten zone underneath the plateau area. The systematic relation between crustal melting and shortening with uplift at the western plateau margin can be traced along most of the plateau flank, with a stepwise decrease in age of deformation and magmatism toward the south indicating discontinuous addition of plateau segments. Crustal thickening to as much as 70 km from westward underthrusting in the back arc parts of the plateau isostatically compensated the tectonic surface uplift and monocline formation with respect to a stable forearc, which only reacted with minor tilting.

No abstract

Tectonic models for the evolution of the Tibetan plateau interpret observed east-west thinning of the upper crust to be the result of either increased potential energy of elevated crust or geodynamic processes that may be unrelated to plateau formation. A key piece of information needed to evaluate these models is the timing of deformation within the plateau. The onset of normal faulting has been estimated to have commenced in southern Tibet between about 14 Myr ago and about 8 Myr ago and, in central Tibet, about 4 Myr ago. Here, however, we report a minimum age of approximately 13.5 Myr for the onset of graben formation in central Tibet, based on mineralization ages determined with Rb-Sr and 40Ar-39Ar data that post-date a major graben-bounding normal fault. These data, along with evidence for prolonged activity of normal faulting in this and other Tibetan grabens, support models that relate normal faulting to processes occurring beneath the plateau. Thinning of the upper crust is most plausibly the result of potential-energy increases resulting from spatially and temporally heterogeneous changes in thermal structure and density distribution within the crust and upper mantle beneath Tibet. This is supported by recent geophysical and geological data, which indicate that spatial heterogeneity exists in both the Tibetan crust and lithospheric mantle.

Employing surface mapping of syntectonic sediments, interpretation of industry reflection‐seismic profiles, gravity data, and isotopic age dating, we reconstruct the tectonic evolution of the southern Altiplano (∼20–22°S) between the cordilleras defining its margins. The southern Altiplano crust was deformed between the late Oligocene and the late Miocene with two main shortening stages in the Oligocene (33–27 Ma) and middle/late Miocene (19–8 Ma) that succeeded Eocene onset of shortening at the protoplateau margins. Shortening rates in the southern Altiplano ranged between 1 and 4.7 mm/yr with maximum rates in the late Miocene. Summing rates for the southern Altiplano and the Eastern Cordillera, we observe an increase from Eocene times to the late Oligocene to some 8 mm/yr, followed by fluctuation around this value during the Miocene prior to shutoff of deformation at 7–8 Ma and transfer of active shortening to the sub‐Andean fold and thrust belt. Shortening inverted early Tertiary graben and half graben systems and was partitioned in three fault systems in the western, central, and eastern Altiplano, respectively. The east vergent fault systems of the western and central Altiplano were synchronously active with the west vergent Altiplano west flank fault system. From these data and from section balancing, we infer a kinematically linked western Altiplano thrust belt that accumulated a minimum of 65 km shortening. Evolution of this belt contrasts with the Eastern Cordillera, which reached peak shortening rates (8 mm/yr) in between the above two stages. Hence local shortening rates fluctuated across the plateau superimposed on a general trend of increasing bulk rate with no trend of lateral propagation. This observation is repeated at the shorter length and time scales of individual growth structures that show evidence for periods of enhanced local rates at a timescale of 1–3 Myr. We interpret this irregular pattern of deformation to reflect a plateau‐style of shortening related to a self‐organized state of a weak crust in the central South American back arc with a fault network that fluctuated around the critical state of mechanical failure. Tuning of this state may have occurred by changes in plate kinematics, during the Paleogene, initially reactivating crustal weak zones and by thermal weakening of the crust with active magmatism mainly in the Neogene stage.

No abstract

Structural, thermochronological and metamorphic data are used to elucidate the tectonic nature and evolution of the ductile extensional Messaria shear zone and the associated brittle Messaria and Fanari detachment faults, which exhumed their footwall from mid-crustal depths on the island of Ikaria in the Aegean. Thermobarometric data indicate that the Messaria shear zone formed at 350–>400 °C and 3–4 kbar (i.e. at a depth of c . 15 km). Normal faulting was accompanied by the intrusion of two granites, which together with the thermobarometric data indicate a relatively high thermal field gradient of 25–35 °C km −1 . Zircon and apatite fission-track and apatite (U–Th)/He ages demonstrate rapid cooling in the footwall of the Messaria detachment from c . 400 °C to c . 40 °C between 11 and 3 Ma. Age–distance relationships of the data suggest that the Messaria shear zone and the Messaria detachment slipped at apparent rates of c . 6–9 km Ma −1 . Kinematic indicators show a consistent top-to-the-NNE shear sense for the extensional faults. However, at the southern part of the Messaria detachment some late-stage shear-sense indicators are top-to-the-SSW and are assumed to be associated with updoming of the footwall. Numerous deformed pegmatite veins in the Messaria shear zone allow the reconstruction of deformation and flow parameters. The mean kinematic vorticity number ranges from 0.13 to 0.80, indicating that shearing deviated significantly from simple shear; that is, extensional shearing was associated with vertical ductile thinning, which contributed to tectonic exhumation. Finite strain shows oblate geometries and axial ratios of the finite-strain ellipse in sections parallel to tectonic transport and normal to the mylonitic foliation range from 1.8 to 19.9. We calculate, using a 1D numerical model, that vertical ductile thinning contributed c . 20% to exhumation during extensional shearing. Normal faulting was the major agent exhuming the footwall from c . 15 km depth.

No abstract