No abstract

Closely-spaced outburst coal seams (COCS) is the main condition of coal seams in southwest China, and gas disasters are one of the major problems affecting coal mine safety. Mining a protective seam and pre gas extraction are the most safety way to improve the efficiency of mining under these conditions. However, low pre-mining gas extraction efficiency coupled with the close proximity of adjacent working faces is a problem. When mining at an old working face has been completed but the new working face is not yet ready to be mined, coal-bed gasses can flow into the new working face from adjacent seams and this commonly causes methane monitoring instruments to sound an alarm. These gas extraction difficulties lead to a conflict between mine safety and profit. To solve these problems, a sequential approach for integrated coal and gas mining of closely-spaced outburst coal seams is introduced in this paper. Two fundamental principles are proposed: (1) Fully coordinating the spatiotemporal relationships between gas extraction, roadway development, and coal mining to maximize both mine safety and coal and gas production; (2) Defining a mining sequence for outburst coal seams and choosing the coal seam with the weakest outburst risk as the protective seam. A system for comprehensive gas extraction in underground coal mines is divided into four stages for gas extraction: gas extraction before coal roadway tunneling, gas extraction before coal mining, gas extraction during coal mining, and gas extraction from the goaf after coal mining. The Songzao mining area, China, is used as a case study to demonstrate the effectiveness of this model, and it brings three major benefits: it improves underground coal mine safety with physical gas accidents decreased by 66.8%, it makes underground coal-bed methane (CBM) extraction more efficient with the average gas extraction rate were respectively 45.13 m3/t and 62.4%, the highest in China, and it reduces greenhouse gas emissions equivalent to 3.5 million tonnes of carbon dioxide. This study could be used as a valuable example for other coal deposits being mined under similar geological conditions.

Initial cracking pressure and locations are important parameters in conducting cross-measure hydraulic fracturing to enhance coal seam permeability in underground coalmines, which are significantly influenced by in-situ stress and occurrence of coal seam. In this study, stress state around cross-measure fracturing boreholes was analyzed using in-situ stress coordinate transformation, then a mathematical model was developed to evaluate initial cracking parameters of borehole assuming the maximum tensile stress criterion. Subsequently, the influences of in-situ stress and occurrence of coal seams on initial cracking pressure and locations in underground coalmines were analyzed using the proposed model. Finally, the proposed model was verified with field test data. The results suggest that the initial cracking pressure increases with the depth cover and coal seam dip angle. However, it decreases with the increase in azimuth of major principle stress. The results also indicate that the initial cracking locations concentrated in the second and fourth quadrant in polar coordinate, and shifted direction to the strike of coal seam as coal seam dip angle and azimuth of maximum principle stress increase. Field investigation revealed consistent rule with the developed model that the initial cracking pressure increases with the coal seam dip angle. Therefore, the proposed

No abstract

No abstract

No abstract

No abstract

No abstract