Carbon fiber-reinforced carbon aerogel composites (C/CAs) for thermal insulators were prepared by copyrolysis of resorcinol-formaldehyde (RF) aerogels reinforced by oxidized polyacrylonitrile (PAN) fiber felts. The RF aerogel composites were obtained by impregnating PAN fiber felts with RF sols, then aging, ethanol exchanging, and drying at ambient pressure. Upon carbonization, the PAN fibers shrink with the RF aerogels, thus reducing the difference of shrinkage rates between the fiber reinforcements and the aerogel matrices, and resulting in C/CAs without any obvious cracks. The three point bend strength of the C/CAs is 7.1 ± 1.7 MPa, and the thermal conductivity is 0.328 W m(-1) K(-1) at 300 °C in air. These composites can be used as high-temperature thermal insulators (in inert atmospheres or vacuum) or supports for phase change materials in thermal protection system.
Polyimide aerogels for low density thermal insulation materials were produced by 4,4'-diaminodiphenyl ether and 3,3',4,4'-biphenyltetracarboxylic dianhydride, cross-linked with 1,3,5-triaminophenoxybenzene. The densities of obtained polyimide aerogels are between 0.081 and 0.141 g cm(-3), and the specific surface areas are between 288 and 322 m(2) g(-1). The thermal conductivities were measured by a Hot Disk thermal constant analyzer. The value of the measured thermal conductivity under carbon dioxide atmosphere is lower than that under nitrogen atmosphere. Under pressure of 5 Pa at -130 °C, the thermal conductivity is the lowest, which is 8.42 mW (m K)(-1). The polyimide aerogels have lower conductivity [30.80 mW (m K)(-1)], compared to the value for other organic foams (polyurethane foam, phenolic foam, and polystyrene foam) with similar apparent densities under ambient pressure at 25 °C. The results indicate that polyimide aerogel is an ideal insulation material for aerospace and other applications.
Multiple myeloma (MM) is an incurable hematological malignancy, although bortezomib has markedly improved its outcomes. Growing clinical evidence indicates that enhancing induced natural killer (NK) or γδ T cells for infusion is useful in the treatment of MM. However, whether combination treatment with bortezomib and induced NK and γδ T cells further improves outcomes in MM, and how the treatments should be combined, remain unclear. Herein, we found that low-dose bortezomib did not suppress the viability of induced NK and γδ T cells, but did induce MM cell apoptosis. Importantly, low-dose bortezomib increased the expression of NKG2D and DNAM-1 ligands on MM cells, which sensitized the multiple myeloma cells to lysis by induced NK and γδ T cells. Our results suggested that combination treatment with low-dose bortezomib and induced NK or γδ T cells had a synergistic cytotoxic effect on MM cells. This study provided a proof of principle for the design of future trials and investigation of this combination therapeutic strategy for MM treatment.
Metal-free bifunctional oxygen electrocatalysts are extremely critical to the advanced energy conversion devices, such as high energy metal-air batteries. Effective tuning of edge defects and electronic density on carbon materials via simple methods is especially attractive. In this work, a facile alkali activation method has been proposed to prepare carbon with large specific surface area and optimized porosity. In addition, subsequent nitrogen-doping leads to high pyridinic-N and graphitic-N contents and abundant edge defects, further enhancing electrochemical activities. Theoretical modeling via first-principles calculations has been conducted to correlate the electrocatalytic activities with their fundamental chemical structure of N doping and edge defect engineering. The metal-free product (NKCNPs-900) shows a high half-wave potential of 0.79 V (ORR). Furthermore, the assembled Zn-air batteries display excellent performance among carbon-based metal-free oxygen electrocatalysts, such as large peak power density up to 131.4 mW cm, energy density as high as 889.0 W h kg at 4.5 mA cm, and remarkable discharge-charge cycles up to 575 times. Preliminarily, the rechargeable nonaqueous Li-air batteries were also investigated. Therefore, our work provides a low-cost, metal-free, and high-performance bifunctional carbon-based electrocatalyst for metal-air batteries.
Abstract-Energy conservation is essential in wireless sensor networks (WSNs) because of limited energy in nodes' batteries. Collaborative beamforming uses multiple transmitters to form antenna arrays; the electromagnetic waves from these antenna arrays can create constructive interferences at the receiver and increase the transmission distance. Each transmitter can use lower power and save energy, since the energy consumption is spread over multiple transmitters. However, if the same nodes are always used, these nodes would deplete their energy much sooner and this sensing area will no longer be monitored. To avoid this situation, energy consumption for collaborative beamforming needs to be balanced over the whole network by assigning the transmitters in turns. The transmitters in each round are selected by a scheduler and the energy carried in each node is balanced to increase the number of transmissions. The lifetime of a network is the number of transmissions until a certain percentage of the nodes depletes their energy. This paper proposes an algorithm to calculate energy-efficient schedules based on the remaining energy and the phase differences of their signals arriving at the receiver. Compared with an existing algorithm, our algorithm can extend the network lifetime by more than 60%.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.