We report the first (to our knowledge) development of a Bi/Er/Al/P codoped germanosilica optical fiber showing ultrabroadband luminescence between 1000 and 1570 nm, covering O-, E-, S-, C-, and L-bands, when pumped by 532, 808, or 980 nm lasers. The fluorescence profiles are found highly pump wavelength dependent, closely associated with different combinations of excitations from both Bi centers and Er ions as active centers. With a proper selection of pump wavelength(s), this Bi/Er codoped fiber could be used as an ultrabroadband gain medium for ultrabroadband amplified spontaneous emission sources, fiber lasers, or amplifiers in telecommunications and in other fields.

We demonstrate the fabrication of long-period fiber gratings (LPFGs) written in the two-mode fiber (TMF) by CO₂ laser. Both uniform and tilted LPFGs were fabricated to provide the light coupling between LP₀₁ mode and LP₁₁ mode with a coupling efficiency of more than 99%. The writing efficiency and the bandwidth of the LPFG mode converter can be adjusted by changing the tilt angle of the tilted TMF-LPFGs. The torsion sensitivity of conventional and tilted LPFG mode converters were measured to be 0.37 nm/(rad/m) and 0.50 nm/(rad/m), respectively. Two orthogonal vector modes (the HEeven 21and HEodd 21 modes) and corresponding orbital angular momentum state were successfully obtained at the resonance wavelength. The proposed LPFG mode converter could be used as not only a high efficiency wavelength tunable mode converter in the mode division multiplexing system but also a high sensitive torsion sensor in the field of optical sensing.

No abstract

Gratings inscribed in polymer optical fibre (POF) have attracted remarkable interest for many potential applications due to their distinctive properties. This paper overviews the current state of fabrication of POF gratings since their first demonstration in 1999. In particular we summarize and discuss POF materials, POF photosensitivity, techniques and issues of fabricating POF gratings, as well as various types of POF gratings.

No abstract

The energy band alignment between HfO2/multilayer (ML)-MoS2 was characterized using high-resolution x-ray photoelectron spectroscopy. The HfO2 was deposited using an atomic layer deposition tool, and ML-MoS2 was grown by chemical vapor deposition. A valence band offset (VBO) of 1.98 eV and a conduction band offset (CBO) of 2.72 eV were obtained for the HfO2/ML-MoS2 interface without any treatment. With CHF3 plasma treatment, a VBO and a CBO across the HfO2/ML-MoS2 interface were found to be 2.47 eV and 2.23 eV, respectively. The band alignment difference is believed to be dominated by the down-shift in the core level of Hf 4d and up-shift in the core level of Mo 3d, or the interface dipoles, which caused by the interfacial layer in rich of F.

No abstract

A europium-doped (Eu-doped) silica optical fiber is fabricated using modified chemical vapor deposition (MCVD) technology. Europium fluoride (EuF₃) material is introduced into the fiber core with a high temperature vaporizing technique. Its concentration is approximately 0.11 at %. The outer and core diameters of doped fiber are approximately 122 and 9 μm, respectively. Refractive index difference (RID) between core and cladding is approximately 2%. A magneto-optical effect measurement system, which is based on the Stokes polarization parameters method, is set up to analyze its magneto-optical properties. The Verdet constant of the Eu-doped optical fiber is -4.563 rad T^-1m^-1, which is approximately double than that of single mode fiber (SMF) at 660 nm.