The discovery of topological semimetal phase in three-dimensional (3D) systems is a new breakthrough in topological material research. Dirac nodal-line semimetal is one of the three topological semimetal phases discovered so far; it is characterized by linear band crossing along a line/loop, contrasted with the linear band crossing at discrete momentum points in 3D Dirac and Weyl semimetals. The study of nodal-line semimetal is still at initial stage; only three material systems have been verified to host nodal line fermions until now, including PbTaSe2 [1], PtSn4 [2]and ZrSiS [3]. In this letter, we report evidence of nodal line fermions in ZrSiSe and ZrSiTe probed in de Haas-van Alphen (dHvA) quantum oscillations. Although ZrSiSe and ZrSiTe share similar layered structure with ZrSiS, our measurements of angular dependences of dHvA oscillations indicate the Fermi surface (FS) enclosing Dirac nodal line is of 2D character in ZiSiTe, in contrast with 3D-like FS in ZrSiSe and ZrSiS. Another important property revealed in our experiment is that the nodal line fermion density in ZrSi(S/Se) (~ 10 20 -10 21 cm -3 ) is much higher than the Dirac/Weyl fermion density of any known topological materials. In addition, we have demonstrated ZrSiSe and ZrSiTe single crystals can be thinned down to 2D atomic thin

Many strongly correlated electronic materials have a domain structure that greatly influences the bulk properties and obscures the fundamental properties of the homogeneous material. Nanoscale samples, on the other hand, can be smaller than the characteristic domain size, thus making it possible to explore these fundamental properties in detail. Here, we report new aspects of the metal-insulator transition, studied in single-domain vanadium dioxide nanobeams. We have observed supercooling of the metallic phase by 50 degrees C, an activation energy in the insulating phase that is consistent with the optical gap, and a connection between the metal-insulator transition and the equilibrium carrier density in the insulating phase. Our devices also provide a nanomechanical method for determining the transition temperature, enable measurements on individual metal-insulator interphase walls to be made, and allow general investigations of phase transitions in quasi-one-dimensional geometries.

No abstract

Despite the relatively simple stoichiometry and structure of VO(2), many questions regarding the nature of its famous metal-insulator transition (MIT) remain unresolved. This is in part due to the prevailing use of polycrystalline film samples and the limited spatial resolution in most studies, hindering access to and control of the complex phase behavior and its inevitable spatial inhomogeneities. Here, we investigate the MIT and associated nanodomain formation in individual VO(2) microcrystals subject to substrate stress. We employ symmetry-selective polarization Raman spectroscopy to identify crystals that are strain-stabilized in either the monoclinic M1 or M2 insulating phase at room-temperature. Raman measurements are further used to characterize the phase dependence on temperature, identifying the appearance of the M2 phase during the MIT. The associated formation and spatial evolution of rutile (R) metallic domains is studied with nanometer-scale spatial resolution using infrared scattering-scanning near-field optical microscopy (s-SNOM). We deduce that even for small crystals of VO(2), the MIT is influenced by the competition between the R, M1, and M2 crystal phases with their different lattice constants subjected to the external substrate-induced stress. The results have important implications for the interpretation of the investigations of conventional polycrystalline thin films where the mutual interaction of constituent crystallites may affect the nature of the MIT in VO(2).