High-stability, zirconium-based metal−organic frameworks are attractive as heterogeneous catalysts and as model supports for uniform arrays of subsequently constructed heterogeneous catalystsfor example, MOF-node-grafted metal−oxy and metal− sulfur clusters. For hexa-Zr(IV)-MOFs characterized by nodes that are less than 12-connected, sites not used for linkers are ideally occupied by reactive and displaceable OH/H 2 O pairs. The desired pairs are ideal for grafting the aforementioned catalytic clusters, while aqua-ligand lability renders them effective for exposing highly Lewis-acidic Zr(IV) sites (catalytic sites) to candidate reactants. New single-crystal X-ray studies of an eight-connected Zr-MOF, NU-1000, reveal that conventional activation fully removes modulator ligands, but replaces them with three node-blocking formate ligands (from solvent decomposition) and only one OH/H 2 O pair, not foura largely overlooked complication that now appears to be general for Zr-MOFs. Here we describe an alternative activation protocol that effectively removes modulators, avoids formate, and installs the full complement of terminal OH/H 2 O pairs. It does so via an unusual isolatable intermediate featuring eight aqua ligands and four non-ligated chloridesagain as supported by single-crystal X-ray data. We find that complete replacement of node-blocking modulators/formate with the originally envisioned OH/OH 2 pairs has striking consequences; here we touch upon just three. First, elimination of unrecognized formate renders aqua ligands much more thermally labile, enabling open Zr(IV) sites to be obtained at lower temperature. Second, in the absence of formate, which otherwise links and locks pairs of node Zr(IV) ions, reversible removal of aqua ligands engenders reversible contraction of MOF meso-and micropores, as evidenced by X-ray diffraction. Third, formate replacement with OH/OH 2 pairs renders NU-1000 ca.10× more active for catalytic hydrolytic degradation of a representative simulant of G-type chemical warfare agents.

The understanding of the catalyst−support interactions has been an important challenge in heterogeneous catalysis since the supports can play a vital role in controlling the properties of the active species and hence their catalytic performance. Herein, a series of isostructural mesoporous metal−organic frameworks (MOFs) based on transition metals, lanthanides, and actinides (Zr, Hf, Ce, Th) were investigated as supports for a vanadium catalyst. The vanadium species was coordinated to the oxo groups of the MOF node in a single-ion fashion, as determined by single-crystal X-ray diffraction, diffuse reflectance infrared Fourier transform spectroscopy, and diffuse reflectance UV−vis spectroscopy. The support effects of these isostructural MOFs were then probed using the aerobic oxidation of 4-methoxybenzyl alcohol as a model reaction. The turnover frequency was found to be correlated with the electronegativity and oxidation state of the metal cations on the supporting MOF nodes, highlighting an important consideration when designing catalyst supports.

This review illustrates molecular-scale confinement, containment, isolation, and related concepts to present MOF-centric catalysts and to realize desired chemical transformations.

No abstract

Few-atom cobalt-oxide clusters, when dispersed on a Zr-based metal-organic framework (MOF) NU-1000, have been shown to be active for the oxidative dehydrogenation (ODH) of propane at low temperatures (<230 °C), affording a selective and stable propene production catalyst. In our current work, a series of promoter ions with varying Lewis acidity, including Ni(II), Zn(II), Al(III), Ti(IV) and Mo(VI), are anchored as metal-oxide,hydroxide clusters to NU-1000 followed by Co(II) ion deposition, yielding a series of NU-1000-supported bimetallic-oxo,hydroxo,aqua clusters. Using difference envelope density (DED) analyses, the spatial locations of the promoter ions and catalytic cobalt ions are determined. For all samples, the promoter ions are sited between pairs of Zr nodes along the MOF c-axis, whereas the location of the cobalt ions varies with the promoter ions. These NU-1000-supported bimetallic-oxide clusters are active for propane ODH after thermal activation under O to open a cobalt coordination site and to oxidize Co(II) to Co(III), as evidenced by operando X-ray absorption spectroscopy at the Co K-edge. In accord with the decreasing Lewis acidity of the promoter ion, catalytic activity increases in the following order: Mo(VI) < Ti(IV) < Al(III) < Zn(II) < Ni(II). The finding is attributed to increasing ease of formation of Co(III)-O species and stabilization of a cobalt(III)-oxyl/propane transition state as the Lewis acidity of the promoter ions decreases. The results point to an increasing ability to fine-tune the structure-dependent activity of MOF-supported heterogeneous catalysts. Coupled with mechanistic studies-computational or experimental-this ability may translate into informed prediction of improved catalysts for propane ODH and other chemical reactions.

Oxygen vacancy is conducive to molecular oxygen adsorption and activation, and it is necessary to estimate its contribution on catalysts, especially the doped system for volatile organic compound (VOC) oxidation. Herein, a series of doped Mn x Zr1–x O2 catalysts with oxygen vacancy were prepared by partially substituting Zr4+ in a zirconia with low-valent manganese (Mn2+). Compared with the corresponding mechanically mixed samples (MB-x) without oxygen vacancy, Mn x Zr1–x O2 catalysts exhibited better toluene conversion and specific reaction rate, where the differential values were calculated to estimate the contribution of oxygen vacancy on catalytic performance. The increase in oxygen vacancy concentrations in Mn x Zr1–x O2 catalysts can boost the differential values, implying the enhancement of oxygen vacancy contribution. Density functional theory (DFT) calculations further confirmed the contribution of oxygen vacancy, and molecular oxygen is strongly absorbed and activated on a defective Mn-doped c-ZrO2 (111) surface with oxygen vacancy rather than a perfect m-ZrO2 (−111) surface or a perfect Mn-doped c-ZrO2 (111) surface, thus resulting in the significant improvement in catalytic activity for toluene oxidation. In situ DRIFTS spectra revealed that the oxygen vacancy can alter the toluene degradation pathway and accelerate the intermediates to convert into CO2 and H2O, thus leading to a low activation energy and high specific reaction rate.

Metal–organic frameworks are versatile materials that provide new opportunities as catalysts in polymerization reactions, including modularity and well-defined structures.

The family of bulk metal phosphorus trichalcogenides (APX3, A = M(II), M(I)(0.5)M(III)(0.5); X = S, Se; M(I), M(II), and M(III) represent Group-I, Group-II, and Group-III metals, respectively) has attracted great attentions because such materials not only own magnetic and ferroelectric properties, but also exhibit excellent properties in hydrogen storage and lithium battery because of the layered structures. Many layered materials have been exfoliated into two-dimensional (2D) materials, and they show distinct electronic properties compared with their bulks. Here we present a systematical study of single-layer metal phosphorus trichalcogenides by density functional theory calculations. The results show that the single layer metal phosphorus trichalcogenides have very low formation energies, which indicates that the exfoliation of single layer APX3 should not be difficult. The family of single layer metal phosphorus trichalcogenides exhibits a large range of band gaps from 1.77 to 3.94 eV, and the electronic structures are greatly affected by the metal or the chalcogenide atoms. The calculated band edges of metal phosphorus trichalcogenides further reveal that single-layer ZnPSe3, CdPSe3, Ag0.5Sc0.5PSe3, and Ag0.5In0.5PX3 (X = S and Se) have both suitable band gaps for visible-light driving and sufficient over-potentials for water splitting. More fascinatingly, single-layer Ag0.5Sc0.5PSe3 is a direct band gap semiconductor, and the calculated optical absorption further convinces that such materials own outstanding properties for light absorption. Such results demonstrate that the single layer metal phosphorus trichalcogenides own high stability, versatile electronic properties, and high optical absorption, thus such materials have great chances to be high efficient photocatalysts for water-splitting.