We report the preparation, characterization, and mechanical properties of DNA/poly(allylamine hydrochloride) (PAH) multilayer microcapsules. The DNA/PAH multilayers were first constructed on a planar support to examine their layer-by-layer buildup. Surface plasmon resonance spectroscopy (SPR) showed a nonlinear growth of the assembly upon each bilayer deposited independently on a concentration of salt. A weak increase in the film thickness with the DNA concentration was, however, detected. A post-treatment of the multilayers in the salt solutions has shown a thinning of the film. The optimal conditions of the planar film growth were used to deposit the same multilayers on the surface of colloidal templates and to study their roughness and morphology with the atomic force microscope (AFM) imaging. When an outer layer is formed by DNA, we observe large domains of oriented parallel DNA loops, while an outer layer formed by PAH shows highly porous morphology. The dissolution of colloidal templates led to a formation of highly porous DNA/PAH microcapsules. We probe their mechanical properties by measuring force-deformation curves with the AFM-related setup. The experiment suggests that the DNA/PAH capsules are softer than capsules made from the flexible polyelectrolytes studied before. The softening is due to both higher permeability and smaller Young's modulus of the shell material. The Young's modulus of the DNA/PAH shells increases after post-treatment in salt solutions of relatively low concentration.

Thin polystyrene films were produced by spin coating from solutions in toluene. The amount of solvent retained in the films after drying for different times was measured using gas chromatography. Whereas for thicker films (thickness > 200 nm), the relative amount of solvent in the films is less than a few percent, the proportion of toluene increases significantly in thinner films. The thickness dependence of the mass of retained solvent shows that the solvent is mainly retained at the polymer-substrate interface. The solvent desorption rate exhibits no variation on the film thickness.

The growth, morphology, and interaction/adhesion properties of supported poly(sodium 4-styrenesulfonate)/poly(allylamine hydrochloride) (PSS/PAH) and DNA/PAH multilayers were investigated by means of surface plasmon resonance spectroscopy, atomic force microscope (AFM) imaging, and AFM-related force measurements. Multilayers were assembled on a prelayer of poly(ethylenimine) (PEI) both with and without drying. SPR results showed a linear growth of the assembly in the case of PSS/PAH multilayers and nonlinear growth for DNA/PAH multilayers. Measurements of forces acting between a bare glass sphere and a multilayer-coated surface indicated repulsive or attractive forces, depending on surface charge, which suggests that, on approach, electrostatic forces dominate. On separation, we observed large pull-off forces in the case of positively charged multilayers and weak pull-off forces in the case negatively charged multilayers. Multiple adhesions and plateau regions observed on separation were interpreted in terms of a bridging of multiple polymer chains between the glass particle and the multilayer and a stretching of the polyelectrolyte loops. The dependence of the pull-off force on the number of deposited layers shows regular oscillations.