No abstract

In this paper, a novel zero current switching (ZCS) flyback inverter in discontinuous conduction mode (DCM) is proposed. In the proposed flyback inverter, the ZCS for the primary switch is achieved by adding a simple auxiliary circuit to the conventional flyback inverter. Also, the auxiliary switch is turned on and turned off at ZCS condition. Therefore, the switching losses of the switches are negligible, which increases the efficiency and allows higher switching frequency and more compact design. The resonant auxiliary cell is activated only in short transition times that makes its conduction losses negligible. Furthermore, the voltage overshoot of the main switch is limited during the turn-off process, which allows utilization of lower voltage metal-oxide semiconductor field-effect transistors (MOSFETs) with low conduction losses and low cost. The detailed operation of the flyback inverter with auxiliary circuit and design considerations are presented. Simulation and experimental results are presented to verify the performance of the proposed inverter.

Summary In this paper, a novel non‐isolated very high step‐up DC‐DC converter is presented. The introduced converter benefits from various advantages, namely, very high voltage gain, low voltage stress on the active switch, and continuous input current with low ripple. Therefore, the presented converter is suitable for renewable energy applications. In addition, the energy of the leakage inductance of the coupled inductor is successfully recovered, and the voltage spike of the active switch is clamped during the turn‐off process. Hence, a switch with low Rds−on can be used, which decreases the conduction losses as well as cost of the converter. Furthermore, the voltage stress of the output diode is decreased, which reduces the reverse recovery problem. The steady‐state analysis and design considerations of the proposed converter are discussed. Finally, the theoretical analysis is validated with the experimental results at an output power of 150 W.

No abstract

No abstract

This paper presents the design, prototyping, and analysis of a novel modular transverse flux permanent magnet disk generator. The disk-shaped structure simplifies the construction procedure by using laminated steel sheets. To reduce output harmonics, the excitation of the generator is done by circular flat shaped Nd-Fe-B permanent magnets. First, a typical low power generator is designed, and then partially optimized. The optimization objective is to find an inner radius which maximizes the power factor, the output power to mass ratio and the efficiency. The generator equivalent circuit parameters are computed by three dimensional finite element analyses. The simulation results show that the power factor of the proposed structure is considerably greater than the power factor previously reported for other transverse flux permanent magnet generator structures. To verify the simulation results, a prototype has been constructed and tested. The experimental results are in good agreement with simulation results.Index Terms-Disk-shaped structure, finite element analyses, power factor, prototype, transverse flux generator.

No abstract

This paper presents a cascaded coil flux control based on a Current Source Parallel Resonant Push-Pull Inverter (CSPRPI) for Induction Heating (IH) applications. The most important problems associated with current source parallel resonant inverters are start-up problems and the variable response of IH systems under load variations. This paper proposes a simple cascaded control method to increase an IH system's robustness to load variations. The proposed IH has been analyzed in both the steady state and the transient state. Based on this method, the resonant frequency is tracked using Phase Locked Loop (PLL) circuits using a Multiplier Phase Detector (MPD) to achieve ZVS under the transient condition. A laboratory prototype was built with an operating frequency of 57-59 kHz and a rated power of 300 W. Simulation and experimental results verify the validity of the proposed power control method and the PLL dynamics.