This study compares a three-phase three-level voltage source inverter with an intermediate dc-dc boost converter and a quasi-Z-source inverter in terms of passive elements values and dimensions, semiconductor stresses, and overall efficiency. A comparative analysis was conducted with relative parameters to evaluate converter parameters for any application. The equations obtained were confirmed by simulation and experimental setup. Field of application has been discussed.

Shoot-through control methods for qZSI-based dc/dc converters are presented and studied. The major goal was to increase efficiency. A new modulation technique, pulse width modulation (PWM) with shifted shoot-through, is compared with the conventional PWM shoot-through control method. The new method reduces switching frequency of bottom side transistors and inherently features partial soft switching. Previous studies have shown that the biggest drawback of PWM control with shoot-through is unequal switching frequencies of transistors. One solution to that problem could be signal swapping that has been proposed by the authors of this paper. All control methods are first simulated and then experimentally verified on a test prototype.

This paper proposes a novel step-up DC/DC converter with galvanic isolation -the quasi-Z-source inverter (qZSI) based DC/DC converter and discusses three different shootthrough PWM control methods suitable for this topology. The proposed converter is meant for applications where the wide range of voltage gain is demanded, e.g. with renewable energy sources (fuel cells, photovoltaic cells), in telecom, aerospace and some other applications. For the verification of theoretical assumptions the converter prototype was assembled and tested. Experimental waveforms of the converter operated with different shoot-through PWM control methods are compared and discussed. Design considerations for converter and different control signal generators are provided. Keywords-DC/DC converter, quasi-Z-source inverter (qZSI), control method, pulse-width modulation (PWM), isolation transformer, gating signal generatorI.

No abstract

Keywords

No abstract

This paper presents a novel quasi-Z-source halfbridge galvanically isolated DC-DC converter intended for the photovoltaic applications. The topology could be envisioned as an alternative to the boost half-bridge DC-DC converter but the benefit of its symmetric structure reduces the threat of transformer saturation due to the dc flux. The proposed converter features the continuous input current and could be used either with one or two input voltage sources.

No abstract