In order to utilize wave energy, various wave power systems are being actively researched and developed and interest in them is increasing. To maximize the operational efficiency, it is very important to monitor and maintain the fault of components of the system. In recent years, interest in the management cost, high reliability and facility utilization of such systems has increased. In this regard, fault diagnosis technology including fault factor analysis and fault reproduction is drawing attention as an important main technology. Therefore, in this study, to reproduce and monitor the faults of a wave power system, firstly, the failure mode of the system was analyzed using FMEA analysis. Secondly, according to the derived failure mode and effect, the thrust bearing was selected as a target for fault reproduction and a test equipment bench was constructed. Finally, with the vibration data obtained by conducting the tests, the vibration spectrum was analyzed to extract the features of the data for each operating status; the data was classified by applying the three machine learning algorithms: naïve Bayes (NB), k-nearest neighbor (k-NN), and multi-layer perceptron (MLP). The criteria for determining the fault were derived. It is estimated that a more efficient fault diagnosis is possible by using the standard and fault monitoring method of this study.
In this paper, the procedure for the strength evaluation of the piping system installed on liquefied natural gas (LNG) carriers is discussed. A procedure that accounts for the ship’s wave load and hull motion acceleration (as well as the deformation due to the thermal expansion and contraction experienced by the hull during seafaring operations) is presented. The load due to the temperature and self-weight of the piping installed on the deck is also considered. Various operating and load conditions of the LNG piping system are analyzed. Stress analysis is performed by combining various conditions of sustained, occasional, and expansion loads. Stress is assessed using finite element analysis based on beam elements that represent the behavior of the piping. The attributes of the piping system components (such as valves, expansion joints, and supports) are represented in the finite element model while CAESAR-II, a commercial software is used for finite element analysis. Component modeling, load assignment, and load combinations are presented to evaluate pipe stresses under various load conditions. An evaluation model is selected for the piping arrangement of LNG and the evaluated stress is compared with the allowable stress defined by the American Society of Mechanical Engineers (ASME).
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.