Differential semblance optimization (DSO) is an approach to inversion of reflection seismograms which avoids the severe convergence difficulties associated with nonlinear least‐squares inversion. The method exploits both moveout and amplitude characteristics of reflections. We have implemented a version appropriate to plane‐wave (p‐tau) seismograms and layered constant‐density acoustic earth models. Theoretical and numerical analyses of this version of DSO indicate that stable and reasonably accurate estimates of both velocity trend and reflectivity can be derived. To test DSO further, we applied it to a marine data set from the Gulf of Mexico, where the method produced results which compare favorably to well‐log information. The method can be extended to incorporate laterally heterogeneous velocity models.

Formation anisotropy should be incorporated into the analysis of controlled source electromagnetic (CSEM) data because failure to do so can produce serious artifacts in the resulting resistivity images for certain data configurations of interest. This finding is demonstrated in model and case studies. Sensitivity to horizontal resistivity will be strongest in the broadside electric field data where detectors are offset from the tow line. Sensitivity to the vertical resistivity is strongest for over flight data where the transmitting antenna passes directly over the detecting antenna. Consequently, consistent treatment of both over flight and broadside electric field measurements requires an anisotropic modeling assumption. To produce a consistent resistivity model for such data we develop and employ a 3D CSEM imaging algorithm that treats transverse anisotropy. The algorithm is based upon non-linear conjugate gradients and full wave equation modeling. It exploits parallel computing systems to effectively treat 3D imaging problems and CSEM data volumes of industrial size. Here we use it to demonstrate the anisotropic imaging process on model and field data sets from the North Sea and offshore Brazil.We also verify that isotropic imaging of over flight data alone produces an image generally consistent with the vertical resistivity. However, superior data fits are obtained when the same over flight data are analyzed assuming an anisotropic resistivity model. 2

No abstract

Large-scale controlled-source electromagnetic (CSEM) threedimensional (3D) geophysical imaging is now receiving considerable attention for electrical-conductivity mapping of potential offshore oil and gas reservoirs. To cope with the typically large computational requirements of the 3D CSEM imaging problem, our strategies exploit computational parallelism and optimized finite-difference meshing. We report on an imaging experiment utilizing 32,768 tasks (and processors) on the IBM Blue Gene/Le (BG/L) supercomputer at the IBM T. J. Watson Research Center. Over a 24-hour period, we were able to image a large-scale marine CSEM field dataset that previously required more than 4 months of computing time on distributed clusters utilizing 1,024 tasks on an InfiniBandt fabric. The total initial data-fitting errors (i.e., ''misfits'' ) could be decreased by 67% within 72 completed inversion iterations, indicating the existence of an electrically resistive region in the southern survey area below a depth of 1,500 m underneath the seafloor. The major part of the residual misfit stems from transmitter-parallel receiver components that have an offset from the transmitter sail line (broadside configuration). Modeling confirms that improved broadside data fits can be achieved by considering anisotropic electrical conductivities. While delivering a satisfactory gross-scale image for the depths of interest, the experiment provides important evidence for the necessity of discriminating between horizontal and vertical conductivities for maximally consistent 3D CSEM inversions.