An emerging sensor technology referred to as electric cell-substrate impedance sensing (ECIS) has been extended for monitoring the behavior of insect cells including attachment, motility, and mortality. In ECIS, adherent cells were cultured on an array of eight small gold electrodes deposited on the bottom of tissue culture wells and immersed in a culture medium. Upon the attachment and spreading of cells on the gold electrode, the impedance increased because the cells acted as insulating particles to restrict the current flow. Experimental data revealed that insect cells interacted differently with various proteins used to precoat the gold electrode with concanavalin A as the best promoter to accelerate the rate of cell attachment. After the cells were fully spread, the measured impedance continued to fluctuate to reflect the constant motion and metabolic activity of the cells. As the cell behavior was sensitive to external chemicals, the applicability of ECIS for inhibition assays was demonstrated with HgCl2, trinitrotoluene, trinitrobenzene (TNB), and 2-amino-4,6-dinitrotoluene as model systems. Unlike conventional assays, the quantitative data obtained in this study are taken in real time and in a continuous fashion to depict cell motility and mortality.
Production of recombinant adeno-associated viral vectors using a baculovirus/insect cell system at various scales is presented. Shake flask studies were conducted to assess conditions to be used in bioreactors. Two insect cell lines, Trichoplusia ni (H5) and Spodoptera frugiperda (Sf9), were compared for their ability to produce rAAV-2 after infection with recombinant baculoviruses coding for the essential components of the vector. The effect of varying the ratio between individual baculoviruses and the effect of the overall multiplicity of infection (MOI), as well as the cell density at infection, were also examined. Infectious rAAV-2 particles were proportionally produced when increasing the individual MOI of BacRep virus up to 1.6. When equal amounts of each virus were used, a leveling effect occurred beyond an overall MOI of 5 and a maximum titer was obtained. Increasing the cell density at infection resulted in higher yields when infecting the cells in fresh medium; however, for the production of bioactive particles, an optimal peak cell density of approximately 1 x 10(6) cells/mL was observed without medium exchange. Infection in 3- and 20-L bioreactors was done at an overall MOI of 5 with a ratio of the three baculoviruses equal to 1:1:1. Under these conditions and infecting the cells in fresh medium, a total of approximately 2.2 x 10(12) infectious viral particles (bioactive particles) or 2.6 x 10(15) viral particles were produced in a 3-L bioreactor. Without replacing the medium at infection, similar titers were produced in 20 L. Our data demonstrates the feasibility of rAAV-2 production by BEVS at various scales in bioreactors and indicates that further optimization is required for production at high cell densities.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.