Production of recombinant adeno-associated viral vectors using a baculovirus/insect cell system at various scales is presented. Shake flask studies were conducted to assess conditions to be used in bioreactors. Two insect cell lines, Trichoplusia ni (H5) and Spodoptera frugiperda (Sf9), were compared for their ability to produce rAAV-2 after infection with recombinant baculoviruses coding for the essential components of the vector. The effect of varying the ratio between individual baculoviruses and the effect of the overall multiplicity of infection (MOI), as well as the cell density at infection, were also examined. Infectious rAAV-2 particles were proportionally produced when increasing the individual MOI of BacRep virus up to 1.6. When equal amounts of each virus were used, a leveling effect occurred beyond an overall MOI of 5 and a maximum titer was obtained. Increasing the cell density at infection resulted in higher yields when infecting the cells in fresh medium; however, for the production of bioactive particles, an optimal peak cell density of approximately 1 x 10(6) cells/mL was observed without medium exchange. Infection in 3- and 20-L bioreactors was done at an overall MOI of 5 with a ratio of the three baculoviruses equal to 1:1:1. Under these conditions and infecting the cells in fresh medium, a total of approximately 2.2 x 10(12) infectious viral particles (bioactive particles) or 2.6 x 10(15) viral particles were produced in a 3-L bioreactor. Without replacing the medium at infection, similar titers were produced in 20 L. Our data demonstrates the feasibility of rAAV-2 production by BEVS at various scales in bioreactors and indicates that further optimization is required for production at high cell densities.
BackgroundCell culture-based production of influenza vaccine remains an attractive alternative to egg-based production. Short response time and high production yields are the key success factors for the broader adoption of cell culture technology for industrial manufacturing of pandemic and seasonal influenza vaccines. Recently, HEK293SF cells have been successfully used to produce influenza viruses, achieving hemagglutinin (HA) and infectious viral particle (IVP) titers in the highest ranges reported to date. In the same study, it was suggested that beyond 4 × 106 cells/mL, viral production was limited by a lack of nutrients or an accumulation of toxic products.ResultsTo further improve viral titers at high cell densities, perfusion culture mode was evaluated. Productivities of both perfusion and batch culture modes were compared at an infection cell density of 6 × 106 cells/mL. The metabolism, including glycolysis, glutaminolysis and amino acids utilization as well as physiological indicators such as viability and apoptosis were extensively documented for the two modes of culture before and after viral infection to identify potential metabolic limitations. A 3 L bioreactor with a perfusion rate of 0.5 vol/day allowed us to reach maximal titers of 3.3 × 1011 IVP/mL and 4.0 logHA units/mL, corresponding to a total production of 1.0 × 1015 IVP and 7.8 logHA units after 3 days post-infection. Overall, perfusion mode titers were higher by almost one order of magnitude over the batch culture mode of production. This improvement was associated with an activation of the cell metabolism as seen by a 1.5-fold and 4-fold higher consumption rates of glucose and glutamine respectively. A shift in the viral production kinetics was also observed leading to an accumulation of more viable cells with a higher specific production and causing an increase in the total volumetric production of infectious influenza particles.ConclusionsThese results confirm that the HEK293SF cell is an excellent substrate for high yield production of influenza virus. Furthermore, there is great potential in further improving the production yields through better control of the cell culture environment and viral production kinetics. Once accomplished, this cell line can be promoted as an industrial platform for cost-effective manufacturing of the influenza seasonal vaccine as well as for periods of peak demand during pandemics.
Metabolic flux quantification of cell culture is becoming a crucial means to improve cell growth as well as protein and vector productions. The technique allows rapid determination of cell culture status, thus providing a tool for further feeding improvements. Herein, we report on key results of a metabolic investigation using 293 cells adapted to suspension and serum-free medium (293SF) during growth and infection with an adenoviral vector encoding the green fluorescence protein (GFP). The model developed contains 35 fluxes, which include the main fluxes of glycolysis, glutaminolysis, and amino acids pathways. It requires specific consumption and production rate measurements of amino acids, glucose, lactate, NH(3), and O(2), as well as DNA and total proteins biosynthesis rate measurements. Also, it was found that extracellular protein concentration measurement is important for flux calculation accuracy. With this model, we are able to describe the 293SF cell metabolism, grown under different culture conditions in a 3-L controlled bioreactor for batch and fed-batch with low glucose. The metabolism is also investigated during infection under two different feeding strategies: a fed-batch starting at the end of the growth phase and extending during infection without medium change and a fed-batch after infection following medium renewal. Differences in metabolism are observed between growth and infection, as well as between the different feeding strategies, thus providing a better understanding of the general metabolism.
In this study the metabolism of 293SF cells grown in serum-free and low-protein medium was analyzed. This cell line is known for its ability to replicate recombinant adenovirus, mainly used in gene therapy applications. A complete model composed of the main glycolytic, glutaminolytic, and amino acids pathways, as well as the internalization fluxes of certain compounds into the mitochondria, is used for metabolic flux calculations. The pentose-phosphate cycle is also added to the biochemical reactions set and was independently measured with labeled 14C-glucose. Different feeding strategies in two different media were analyzed with the model, and the theoretical ATP production was also calculated. The two media were similar in their glucose and amino acid composition, but one contained BSA at 1g/L whereas the other had a very low protein content. Use of low-protein medium resulted in up to fourfold higher adenoviral vector production. In this medium, glucose utilization was more efficient, as it entered the TCA cycle more efficiently. Also, lower glutamine and amino acids consumption were observed as well as lower lactate and ammonia production. This increased TCA activity led to a twofold higher ATP production in the low-protein medium.
Human 293S cells culture for recombinant adenovirus production is traditionally carried out in batch at a maximum of 6 x 10(5) cells/mL. A previous report demonstrated that fed-batch, applied to the adenovirus/293S cells system, improves the volumetric production of viral proteins by increasing the cell density at which cells can be infected, up to 2 x 10(6) cells/mL, without reducing the per-cell yield of product. To increase this cell density limit, the adenovirus production was performed in a perfusion system where the cells were separated by means of a tangential flow filtration device. 293S cell growth to 14 x 10(6) cells/mL was achieved in 10 days, at a medium renewal rate of 1 volume of medium per reactor volume and day (VVD). For adenovirus production, three 293S cell cultures were perfused at 1 VVD in parallel and infected at an average density of 8 x 10(6) cells/mL. One of the cultures was set at 37 degrees C and the two others at 35 degrees C. After a rapid initial cell loss, the average cell density stabilized at 5.75 x 10(6) cells/mL, 12 h postinfection, which was 8 times higher than the cell density in the batch control. This allowed the production of 3.2 x 10(9) infectious viral particles/mL (IVP/mL) at 37 degrees C and 7.8 x 10(9) IVP/mL at 35 degrees C, this last result being 5.5 times higher than the control. To our knowledge, this nonconcentrated titer is the highest value that has ever been published for adenovirus vector production. These observations lead to the conclusion that perfusion is an efficient tool to maintain, at high cell density, a specific production rate level sufficient to increase significantly the adenovirus volumetric production. Furthermore, it shows that perfusion at 35 degrees C can improve viral titer by 2.4-fold compared to 37 degrees C, in accordance with a previous study on adenovirus batch production.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.