Abstract. The organic fraction of atmospheric aerosols contains a multitude of compounds and usually only a small fraction can be identified and quantified. However, a limited number of representative organic compounds can be used to describe the water-soluble organic fraction. In this work, initiated within the EU 5FP project SMOCC, four mixtures containing various amounts of inorganic salts (ammonium sulfate, ammonium nitrate, and sodium chloride) and three model organic compounds (levoglucosan, succinic acid and fulvic acid) were studied. The interaction between water vapor and aerosol particles was studied at different relative humidities: at subsaturation using a hygroscopic tandem differential mobility analyzer (H-TDMA) and at supersaturation using a cloud condensation nuclei spectrometer (CCN spectrometer). Surface tensions as a function of carbon concentrations were measured using a bubble tensiometer. Parameterizations of water activity as a function of molality, based on hygroscopic growth, are given for the pure organic compounds and for the mixtures, indicating van't Hoff factors around 1 for the organics. The Zdanovskii-Stokes-Robinson (ZSR) mixing rule was tested on the hygroscopic growth of the mixtures and it was found to adequately explain the hygroscopic growth for 3 out of 4 mixtures, when the limited solubility of succinic acid is taken into account. One mixture containing sodium chloride was studied and showed a pronounced deviation from the ZSR mixing rule. Critical supersaturations calculated using the parameterizations of water activity and the measured surface tensions were compared with those determined experimentally.

Aliphatic straight-chain dicarboxylic acids have been identified as common water-soluble organic components of atmospheric aerosols. To model the partitioning of such compounds between gas and particle phase in the atmosphere, information about their vapor pressures is essential. In this work, vapor pressures of C3-C9 dicarboxylic acids are derived from measured evaporation rates of submicron aerosols over the temperature range of 290-314 K using the tandem differential mobility analyzer technique. Vapor pressures obtained from the experimental data were as follows: log(p°m alonic , Pa) ) -4822 K/T + 12.9, log(p°s uccinic , Pa) ) -7196.8 K/T + 19.8, p°g lutaric (296 K) ) 6.7 × 10 -4 Pa, log(p°a dipic , Pa) ) -8065.0 K/T + 22.2, log(p°p imelic , Pa) ) -7692.8 K/T + 21.8, log(p°s uberic , Pa) ) -9629.4 K/T + 26.5, and log(p°a zelaic , Pa) ) -7968.7 K/T + 21.7. Vapor pressures of C3-C9 dicarboxylic acids are shown to alternate strongly with the parity of the number of carbon atoms. Higher vapor pressures of the odd acids fit the less stable crystal structure, the propensity of polymorphism in the odd acids, and the evolution of melting temperatures. Results are compared with available literature data.

No abstract

No abstract

The present investigation, carried out as a case study in a typical major city situated in a European coal combustion region (Krakow, Poland), aims at quantifying the impact on the urban air quality of residential heating by coal combustion in comparison with other potential pollution sources such as power plants, industry, and traffic. Emissions were measured for 20 major sources, including small stoves and boilers, and the particulate matter (PM) was analyzed for 52 individual compounds together with outdoor and indoor PM10 collected during typical winter pollution episodes. The data were analyzed using chemical mass balance modeling (CMB) and constrained positive matrix factorization (CMF) yielding source apportionments for PM10, B(a)P, and other regulated air pollutants namely Cd, Ni, As, and Pb. The results are potentially very useful for planning abatement strategies in all areas of the world, where coal combustion in small appliances is significant. During the studied pollution episodes in Krakow, European air quality limits were exceeded with up to a factor 8 for PM10 and up to a factor 200 for B(a)P. The levels of these air pollutants were accompanied by high concentrations of azaarenes, known markers for inefficient coal combustion. The major culprit for the extreme pollution levels was demonstrated to be residential heating by coal combustion in small stoves and boilers (>50% for PM10 and >90% B(a)P), whereas road transport (<10% for PM10 and <3% for B(a)P), and industry (4-15% for PM10 and <6% for B(a)P) played a lesser role. The indoor PM10 and B(a)P concentrations were at high levels similar to those of outdoor concentrations and were found to have the same sources as outdoors. The inorganic secondary aerosol component of PM10 amounted to around 30%, which for a large part may be attributed to the industrial emission of the precursors SO2 and NOx.

Revised review paper intended for publication in the special issue of Waste Management "Landfill Gas EmissionMonitoring".

No abstract

No abstract