No abstract

Concentrating Solar Power (CSP) plants tend to be located in open areas. This leads to the power plant usually being subjected to high wind speeds without much shelter or protection. In parabolic trough plants the solar field, the collectors and receiver tubes, are affected by the wind on both the structural, as well as the performance level. The collectors must resist the aerodynamic forces caused by the wind, and the airflow around the receiver tube has a cooling effect on it. The effects of the wind on Parabolic Trough Collectors (PTC) were investigated in a parametric study over a large range of pitch and yaw angles. Three different trough geometries were analysed varying the focal length of the parabola, i.e. the depth of the trough. The data were obtained using the Computational Fluid Dynamics (CFD) package ANSYS CFX 15.0 and validated against experimental data.An increase of the depth of the parabolic trough increases the maximum aerodynamic forces on the trough. However, a deeper trough has a sheltering effect on the receiver tube, thus reducing the thermal losses due to forced convection. This effect becomes more important the higher the temperature difference between the receiver and ambient air, and it can also reduce the requirements for highly insulated evacuated receiver tubes, which are a significant cost factor in PTC plants.The highest force coefficients on the PTC are observed at high positive pitch angles and a yaw angle of 0 • . While the aerodynamic loads on the trough reduce significantly with an increase in the yaw angle of the approaching wind, the heat flux around the receiver tube only shows a slight decrease in most cases. At some negative pitch angles an increasing yaw angle leads to higher thermal losses, as a vortex, forming at the leading edge of the trough, causes high air velocities around the receiver.

No abstract

No abstract

Abstract. Parabolic trough power plants are often located in areas that are subjected to high wind speeds, as an open terrain without any obstructions is beneficial for the plant performance. The wind impacts both the structural requirements and the performance of the plant. The aerodynamic loads from the wind impose strong requirements on the support structure of the reflectors, and they also impact the tracking accuracy. On a thermal level the airflow around the glass envelope of the receiver tube cools its outer surface through forced convection, thereby contributing to the heat loss.Based on previous studies at the level of an individual row of collectors, this study analyses the wind effects in a full-scale solar field of different continuous and staggered trough designs. The airflow around several rows of parabolic trough collectors (PTC) is simulated at full scale in steady state simulations in an atmospheric boundary layer flow using the commercial computational fluid dynamics software ANSYS R CFX 15.0. The effect of the wake of a collector row on the following collectors is analysed, and the aerodynamic loads are compared between the different geometries.The outermost collectors of a solar field experience the highest wind forces, as the rows in the interior of the solar field are protected from high wind speeds. While the aerodynamic forces in the interior of the solar field are almost independent of the collector shape, the deeper troughs (with large rim angles) tested in this study show a lower heat loss due to forced convection on the outer surface of the receiver tube than the shallower ones (with small rim angles) in most of the solar field.

No abstract