We observed a scaling behavior during the shadowing growth of isolated Si, Co, Cu, and W nanocolumnar structures on Si substrates using the oblique angle deposition with substrate rotation ͑also known as glancing angle deposition or simply GLAD͒. The width of the isolated columns, W, grew as a function of column length, d, in a power law form, Wϳd p , where p is the growth exponent and was measured to be ϳ0.28-0.34. It is argued that shadowing without diffusion should lead to pϭ0.50 and would cross over to 0.31 if one considers surface diffusion. It is of great interest to determine the mechanisms that would affect the value of p since it is an important factor that would control the shape, final size, and spacing of the isolated nanocolumns eventually produced.

We report the creation of an unusual simple cubic ␤-phase W͑100͒ nanorods with a pyramidal tip having four ͑110͒ facets using an oblique-angle sputter deposition technique with substrate rotation ͑also known as glancing-angle deposition͒. During the oblique-angle deposition, both ␤-phase W͑100͒ and ␣-phase W͑110͒ islands exist at the initial stages of growth. The ␤-phase W͑100͒ islands grow taller due to the lower adatom mobility on these islands. The taller islands survive in the competition and form isolated nanorods in the later stages of growth. This is in contrast to the sputter deposition at normal incidence, where only the thermodynamically stable bcc ␣-phase W͑110͒ polycrystalline films were formed when the film grows to a certain thickness.

No abstract

No abstract

We report a cost effective and facile way to synthesize flexible, uniform, and large area surface enhanced Raman scattering (SERS) substrates using an oblique angle deposition (OAD) technique. The flexible SERS substrates consist of 1 μm long, tilted silver nanocolumnar films deposited on flexible polydimethylsiloxane (PDMS) and polyethylene terephthalate (PET) sheets using OAD. The SERS enhancement activity of these flexible substrates was determined using 10(-5) M trans-1,2-bis(4-pyridyl) ethylene (BPE) Raman probe molecules. The in situ SERS measurements on these flexible substrates under mechanical (tensile/bending) strain conditions were performed. Our results show that flexible SERS substrates can withstand a tensile strain (ε) value as high as 30% without losing SERS performance, whereas the similar bending strain decreases the SERS performance by about 13%. A cyclic tensile loading test on flexible PDMS SERS substrates at a pre-specified tensile strain (ε) value of 10% shows that the SERS intensity remains almost constant for more than 100 cycles. These disposable and flexible SERS substrates can be integrated with biological substances and offer a novel and practical method to facilitate biosensing applications.

A sixfold decrease in photoluminescence signal intensity at 590nm with increase in deposition time from 3to12h has been observed in single crystalline indium oxide octahedron structures grown by vapor-phase evaporation method. Electron paramagnetic resonance and energy dispersive x-ray analysis confirm that the concentration of oxygen vacancies increases with deposition time. These results are contrary to the previous reports where oxygen vacancies were shown to be responsible for photoluminescence in indium oxide structures. Our results indicate that indium interstitials and their associated complex defects other than oxygen vacancies are responsible for the photoluminescence in In2O3 microstructures.

The rapid industrial growth has led to the large production of oily wastewater. Treatment of oily wastewater is an inevitable challenge to manage the greater demand of clean water for the rapidly growing population and economy. In the present work, we have developed a smart surface mesh with reversible wetting properties via a simple, ecofriendly, and scalable approach for on-demand oil-water separation. ZnO nanowires (NWs) obtained from the chemical vapor deposition method were coated on a stainless steel (SS) mesh. The as-synthesized ZnO-NWs-coated mesh shows superhydrophilic/underwater superoleophobic behavior. This mesh works in "water-removing" mode, where the superhydrophilic as well as underwater superoleophobic nature allows the water to permeate easily through the mesh while preventing oil. The wetting property of ZnO-NWs-coated mesh can be switched easily from superhydrophilic to superhydrophobic state and vice versa by simply annealing it at 300 °C alternatively under hydrogen and oxygen environment. The separation is solely driven by gravity. Thus, the reversible wettability of ZnO NWs provides a smart surface mesh which can be switched between "oil-removing" and "water-removing" modes. It was found that for more than 10 cycles of mesh reutilization in both modes alternatively, the separation efficiency of 99.9% stayed relatively invariant, indicating a prolonged antifouling property and excellent recyclability. This work provides a simple, fast, cost-effective, and on-demand solution for oily wastewater treatment and opens up new perspectives in the field of controllable oil-water separation.

No abstract