Objective: In this case report, the feasibility and precision of tridimensional (3D) virtual planning in one patient with craniofacial microsomia is tested using Nemoceph 3D-OS software (Software Nemotec SL, Madrid, Spain) to predict postoperative outcomes on hard tissue and produce CAD/CAM (Computer Aided Design/Computer Aided Manufacturing) surgical splints. Methods: The clinical protocol consists of 3D data acquisition of the craniofacial complex by cone-beam computed tomography (CBCT) and surface scanning of the plaster dental casts. The ''virtual patient'' created underwent virtual surgery and a simulation of postoperative results on hard tissues. Surgical splints were manufactured using CAD/CAM technology in order to transfer the virtual surgical plan to the operating room. Intraoperatively, both CAD/CAM and conventional surgical splints are comparable. A second set of 3D images was obtained after surgery to acquire linear measurements and compare them with measurements obtained when predicting postoperative results virtually.Results: It was found a high similarity between both types of surgical splints with equal fitting on the dental arches. The linear measurements presented some discrepancies between the actual surgical outcomes and the predicted results from the 3D virtual simulation, but caution must be taken in the analysis of these results due to several variables. Conclusions: The reported case confirms the clinical feasibility of the described computer-assisted orthognathic surgical protocol. Further progress in the development of technologies for 3D image acquisition and improvements on software programs to simulate postoperative changes on soft tissue are required.

No abstract

The test ABM/P-15 CMC-hydrogel graft material behaved in this animal model by migration of the graft particles, what determined an unpredictable osseoconduction and, consequently, a decreased quality and quantity of bone regeneration as compared with the osseopromotive behavior exhibited by the standard particulate form of the ABM/P-15 control graft. It is therefore suggested to restrain the application of the hydrogel graft form in non-contained anatomical bone defects.

Airway management is one of the most important anaesthetist's skills as major complications of airway management, although rare, can be among the most life threatening in medicine. Crouzon syndrome is a rare condition with physical characteristics that can result in difficult airway manipulation. A correct preanaesthetic evaluation and a planned preinduction strategy should be designed to facilitate intubation.

Background: The osteogenesis distraction technique applied to the craniofacial skeleton is an alternative treatment for dentofacial deformities. Despite the advantages of tooth-borne distractors, few studies have evaluated their clinical implementation in sagittal dentoskeletal deformities. This study aimed provide a radiographic assessment of the effect of two different activations of tooth-borne distraction in the lengthening of the mandible in canines. Material and methods: Ten male beagle dogs, approximately one year old, were used for this experimental study. Three remained as a control group and seven underwent a mandibular tooth-borne distraction protocol with single daily activation in one hemimandible and two daily activations in the other, during ten days. The consolidation period took 12 weeks. Occlusal radiographs were performed immediately pre-and postoperatively. Results: After the distraction period, the host bone margins presented very well-defined outlines with regular contours. Concerning the consolidation period, between the second and fourth weeks, all hemimandibles showed small rectangular radiopaque regions with parallel orientation to the distraction axis. At the twelfth week, all hemimandibles presented an entire mineralization of the distraction gap with no axial deviations of the anterior and posterior host bone, nine of which with both margins showing corticalization. Conclusions: Radiographic analysis showed bone regeneration in order to achieve the original bone architecture, especially in the group of multiple distraction. Tooth-borne distraction allowed successful sagittal lengthening of the mandible in a canine model.