In order to study the impact of different gas compositions on the bactericidal efficiency of cold atmospheric plasma jets, a device with a controlled atmosphere is built. Various mixtures of argon and helium with air are studied regarding their sterilizing effect on Escherichia coli in solution. Bacteria reduction rates react fundamentally different on addition of air in both gases. In case of helium, a distinct maximum for small admixtures is observed. Several diagnostic techniques were applied to the plasma. Stronger formation of peroxynitrous acid due to higher concentrations of hydrogen peroxide and nitrite is found to be responsible for the observed trends and differences. The presented findings are important for the development of efficient treatment devices.

A transient plasma created by a low-pressure dielectric-barrier discharge operated with argon was investigated by means of optical emission spectroscopy and imaging. Images of the discharge and emission spectra were recorded with sub-phase resolution and relative densities of excited argon states were obtained. Profiles of densities and electron temperatures were evaluated for the discharge cycle by comparison with results of a collisional-radiative model (CRM). To overcome difficulties in sub-cycle modelling of the important argon 1s states, a combination of the CRM with a density estimation based on radiation-trapping is proposed. Absolute densities of all four 1s states were measured and additionally verified by tunable laser absorption spectroscopy. The presented combination may help to improve optical diagnostics of rare gas plasmas in cases were the dominating processes for the 1s states are not known with sufficient accuracy.

The temporal evolution of a low pressure argon plasma driven by a combination of radio frequency and kilohertz frequency power sources was characterized by phase resolved optical emission and laser absorption spectroscopy. The compact, low pressure plasma was formed in a hybrid surface/jet geometry and powered by a high voltage power supply operating at 31 kHz and by a lower voltage RF supply operating at 13.56 MHz. An accurate evaluation of the 1s state density dynamics was performed by means of laser absorption measurements of the 1s5 and 1s4 sublevels. The emission spectra were recorded with a submicrosecond temporal resolution and evaluated using an extended Corona model. In comparison with the modeling results, the phase dependent ratio of different Ar(2p) → Ar(1s) emission lines was used to determine temporal profiles of electron temperature and relative electron density. The results were compared with the results from time averaged emission measurements by performing an identical analysis. Strong spatial and temporal variations of plasma parameters were observed when the plasma was driven solely by the 31 kHz source, resulting in nonequilibrium conditions for long living states. Inconsistent observations in the reconstructed temporal development of plasma energy and density were further investigated by illustrating full spatiotemporal reconstruction of plasma parameters. These results permit clear identification of strong spatial gradients through the tube.

A recently published method for the analysis of phase-resolved optical emission spectra was extended in order to permit estimation of time-resolved electron density profiles. The previously presented method combined collisional-radiative modelling with a self-absorption method to estimate the evolution of T e with sub-cycle time-resolution. However, it was not capable to give similar profiles for n e as the model was insensitive to its variations. The extensions proposed in this work describe a way to also estimate the electron density with sub-cycle time resolution from the changing rates of the argon Paschen 1s states. The method was applied to a low-pressure DBD-jet operated with argon and several argon–nitrogen mixtures with up to 4% N2. Good agreement among evaluation of n e from changing rates of individual 1s states was observed during the collisional phase and the full-cycle temporal profile could be calculated from relative changes in light emission. Electron densities exhibited a drop for larger admixtures of nitrogen and ranged from 1017 m−3 to 1018 m−3. As assumed in a previous work, the electron temperature model worked without explicit consideration of additional processes even when N2 affected the plasma. However, presumably due to collisional quenching by nitrogen, two argon Paschen 2p levels were found to be inappropriate for T e estimation and had to be removed. Values for electron temperature from the remaining levels remained at a similar value as for pure argon.

The influence of the atom source operating parameters on the structural and optical properties of InxGa1−xN/GaN nanowires (NWs) grown by plasma-assisted molecular beam epitaxy is investigated. Electron microscopy and photoluminescence spectroscopy reveal a change of the NW tip morphology and an enhancement of the local indium incorporation with increasing nitrogen flux. Tuning the density ratio of atomic-to-excited molecular nitrogen to lower values minimizes the point defect density, which results in a decrease of the non-radiative recombination rate as demonstrated by a combination of continuous wave and time-resolved photoluminescence spectroscopy.