After many years of fusion research, the conditions needed for a D–T fusion reactor have been approached on the Tokamak Fusion Test Reactor (TFTR) [Fusion Technol. 21, 1324 (1992)]. For the first time the unique phenomena present in a D–T plasma are now being studied in a laboratory plasma. The first magnetic fusion experiments to study plasmas using nearly equal concentrations of deuterium and tritium have been carried out on TFTR. At present the maximum fusion power of 10.7 MW, using 39.5 MW of neutral-beam heating, in a supershot discharge and 6.7 MW in a high-βp discharge following a current rampdown. The fusion power density in a core of the plasma is ≊2.8 MW m−3, exceeding that expected in the International Thermonuclear Experimental Reactor (ITER) [Plasma Physics and Controlled Nuclear Fusion Research (International Atomic Energy Agency, Vienna, 1991), Vol. 3, p. 239] at 1500 MW total fusion power. The energy confinement time, τE, is observed to increase in D–T, relative to D plasmas, by 20% and the ni(0) Ti(0) τE product by 55%. The improvement in thermal confinement is caused primarily by a decrease in ion heat conductivity in both supershot and limiter-H-mode discharges. Extensive lithium pellet injection increased the confinement time to 0.27 s and enabled higher current operation in both supershot and high-βp discharges. Ion cyclotron range of frequencies (ICRF) heating of a D–T plasma, using the second harmonic of tritium, has been demonstrated. First measurements of the confined alpha particles have been performed and found to be in good agreement with TRANSP [Nucl. Fusion 34, 1247 (1994)] simulations. Initial measurements of the alpha ash profile have been compared with simulations using particle transport coefficients from He gas puffing experiments. The loss of alpha particles to a detector at the bottom of the vessel is well described by the first-orbit loss mechanism. No loss due to alpha-particle-driven instabilities has yet been observed. D–T experiments on TFTR will continue to explore the assumptions of the ITER design and to examine some of the physics issues associated with an advanced tokamak reactor.

No abstract

No abstract

Observation of the intensity of the recycling particle flux at the main plasma edge for various limiter and divertor discharges indicates that the gross energy confinement of beam-heated discharges is closely related to the intensity of the edge particle flux. In limiter discharges, the global particle confinement time and the energy confinement time τE show many similarities: 1) linear Ip dependence at Ip < 600 kA, 2) no BT dependence, and 3) deterioration against injection power. Improvement of τE by increasing Ip, for example, is associated with high temperatures at the plasma edge region accompanied by reduced particle recycling. – Divertor discharges with low particle recycling around the main plasma show better energy confinement than limiter discharges at high plasma densities. The improvement of τE is primarily originated in the reduction of heat transport at the main plasma edge region, which is associated with the reduction of recycling particle flux at the main plasma edge. Under certain operation condition, for example, excessive cold-gas puffing, the discharge shows relatively high scrape-off plasma density and strong particle recycling between the main plasma and the limiter. The energy confinement time of these discharges degrades somewhat or reduces completely to that of the limiter discharge. – In low-recycling divertor discharges, the central electron and ion temperature is proportional to the injection power, and the plasma stored energy is proportional to n̄ePabs (scales as INTOR scaling). With ≈ 4 MW beam injection, high-temperature and high-density plasmas were obtained (stored energy up to 280 kJ, Te(0) ≈ Ti(0) ≈ 2.5–3.0 keV at n̄e ≈ (6–7) × 1013 cm−3, τE* ≈ 70 ms).