The Welding Institute of Canada (WIC) test is a simple and standardised weldability test for hydrogen assisted cold cracking that was developed in the 80s. It has been extensively utilised by the industry to qualify safe welding envelopes but the difficult access to the weldment by instrumentation hinders its use for scientific research. Moreover the lack of repeatability arising from the traditional manual deposit and the short weld length causes industrial trials to have a low success rate. The present work proposes a modified geometry, referred to as the modified WIC (MWIC) test that shows: (1) an improved success rate of weld deposition, (2) an enhancement to instrument the weldment and (3) welding conditions in better accordance with the field pipeline girth welding conditions. The design is validated under a mechanised, shielded metal arc welding process with the cellulosic electrodes used for in-field pipeline construction.

High-pH stress corrosion cracking is a form of environmental degradation of gas pipeline steels. The crack path is intergranular by nature and typically perpendicular to the maximum applied (hoop) stress (i.e. perpendicular to the pipe outer surface). Some unusual instances of cracks have been observed in Canadian and Australian X65 pipes, where cracks grow away from the perpendicular for considerable distances. This paper presents a comparative study in terms of crack morphology, mechanical properties and crystallographic texture for these Australian and Canadian pipe steels. It is shown that the crack morphologies are quite similar, the main difference being the angle at which the cracks propagate into the material. This difference could be explained by the different through-wall texture and grain aspect ratio measured in the two materials. The interdependency of crack tip plasticity, crack tip electrochemistry and anisotropy in microstructural texture seems to heavily affect the resulting inclined crack path.

Modelling of intergranular stress corrosion cracking (SCC) in pipelines is an important field of study as predictive techniques are integral to pipeline integrity and management. An inclination of the SCC propagation direction has been observed for some pipelines, which is not predictable using existing models as they assume perpendicular crack growth. A review has been conducted to identify the applicable techniques from existing models, as well as the gaps in current knowledge. Existing work in crack growth rates, stress formulations and microstructural representations are reviewed. Mechanical dependency of the electrochemical response is identified as a gap and proposed for inclusion in a model alongside the other areas reviewed.

Inclined high pH stress corrosion cracking (SCC) is a type of intergranular environmental cracking in gas pipelines, which differs from typical SCC by propagating at an angle from the wall direction. Investigations of Australian and Canadian inclined SCC colonies have not provided a clear indicator of a cause for the abnormal crack growth direction. This paper addresses the possibility of crack tip strain enhanced electrochemistry causing the inclination. Potentiodynamic tests were conducted to quantify the influence of strain on the electrochemistry, and strain was found to increase current density up to 300% in the SCC region. A model was developed that incorporates crack tip strain driven SCC growth, which showed good agreement with field grown cracks, and the aspect ratio of the grains was shown to have an effect on the inclination angle. The results indicate that crack tip strain enhanced electrochemistry is a plausible cause for inclined SCC.

No abstract