Five long-legged buzzards (Buteo rufinus), weighing 475-570 g, were used in this study. It was determined that long-legged buzzards' larynx is composed of three different cartilages. Among these cartilages, the cricoid and procricoid cartilages were single and the arytenoid cartilage was double. The partially ossified corpus and ala of the cricoid cartilage were connected with cartilaginous plate. Trachea was formed up of complete cartilage circles. The tracheal cartilages were notched in dorsal and ventral directions and a number of the tracheal cartilages inter-mingling one another were between 89-96. Syrinx, which was covered with the inter-clavicular air sac, was in contact with basis cordis. It was observed that there is tracheobronchial type syrinx in long-legged buzzard and this syrinx is formed by two different cartilage groups named as the cartt. tracheosyringeales and cartt. bronchosyringeales. The first cartilage rings of the cartt. tracheosyringeales formed the tympanum. The tympanum, cartt. tracheosyringeales and cartt. bronchosyringeales were created of three, two or three and four cartilage rings, respectively. Membrana tympaniformis lateralis and medialis, two pairs of thin membranes constituting voice formation, also determined in long-legged buzzard. Membrana tympaniformis lateralis was observed to be very short between the first and second cartilage rings of cartt. bronchosyringeales. Although the instrictic syringeal muscles were not present in long-legged buzzard, the sternotracheal and tracheolateral muscles, expressed as extrinsic syringeal muscles, were evident. In this study, which is expected to give contribution to veterinary anatomy literature, the similarities and differences in larynx, trachea and syrinx of long-legged buzzard with other bird species were exposed.

In this study, the left and right cranial cervical ganglia (ganglion cervicale craniale) of eight young (four male, four female) domestic pigs weighing around 70-80 kg were inspected macro anatomically. The cranial cervical ganglion (CCG) was found cranio-ventrally of the distal ganglion of the vagus nerve, medial of the jugular process extremity, ventral of the atlas, dorsal of the epiglottis base and medial of the common root (CR) established by the internal carotid and occipital arteries. The internal carotid nerve and jugular nerve ramified from the cranial part of CCG. The jugular nerve gave branches that merged with the vagus and glossopharyngeal nerves. Other nerve branches originating from the cranial part of the ganglion reached to the external carotid artery and CR. The internal carotid nerve varied among cadavers in number of branches (two to four). These branches did not travel along the side of the internal carotid artery. The central part of CCG gave thin nerve branches that reached to various anatomical structures including the first and second cervical nerves, wall of the pharynx, accessory nerve, hypoglossal nerve, vagus nerve, external carotid artery and CR. The caudal part of CCG gave nerve branches that merged with the vagus, cranial laryngeal nerves, and common carotid artery. The external carotid nerves, which were two or three in number, also originated from the caudal part of CCG. In conclusion, the nerves ramifying from CCG of the pig varied in number among cadavers. Compared with literature raised in other species, there are also differences in number of nerve branches and course pattern of these nerves.

This study has been conducted on the knee joints of the New Zealand rabbits. A total of 20 knee joints from 10 (five female, five male) adult New Zealand rabbits were studied in the study. Fourteen ligaments and four sesamoid bones including the patellar bone, the infrapatellar adipose body, and the suprapatellar cartilage specifically present in rabbits were grossly observed. The caudal meniscotibial ligaments of the lateral meniscus were noted to be lacking in these rabbits. Moreover, the medial collateral ligament did not have a capsular character in nature. Thus, adipose tissue was determined at a point where the suprapatellar cartilage and patella fused.

Eight female New Zealand rabbits were used. The bulbus oculi was removed bilaterally from orbita then intraorbital muscles were revealed by dissection and their length and breadth and the distance of the muscle insertion to the corneal limbus were measured. Junction formations of the insertion tendon of intraorbital muscle to the sclera were identified.

In this study, it was aimed to obtain 3-dimensional (3D) digital and printed models of healthy forelimb joints using micro-computed tomography (µCT) technique in New Zealand Rabbit, which is frequently preferred in experimental orthopedic studies. Moreover, it was aimed to provide morphometric measurements on the shoulder and elbow joints over 3D digital models. A total of 14 adults (7 female, 7 male) New Zealand Rabbits were used in the study. After imaging the forelimbs with the µCT device, 3D digital and printed models were obtained. Biometric measurements of shoulder and elbow joints were performed over 3D digital models and the data obtained from female and male rabbits were evaluated statistically. The anatomical structure on the 3D joint models was very detailed due to the low section thickness and high detector quality. 3D printed models produced as a result of the 3D printing process were quite durable, odorless, and clean. No anatomical differences were observed between 3D printed models and 3D digital models. In this study, it is thought that the anatomical and morphometric data obtained from laboratory rabbits will contribute to scientists take part both in experimental orthopedic intervention and clinical anatomy education.

The department of National Parks and Protection of Wild Nature sent five (two males, three females) adult long-legged buzzards for investigation of their deaths to Ankara University Veterinary Faculty. Facial bones of buzzards were evaluated. Distinguishing facial features such as strong os premaxillare, cavum nasale filled with spider webbing-like structures, prominent os prefrontalis and processes, H-shaped paraglossum were determined. In this study, we investigated the anatomic properties of facial bones in long-legged buzzard. We also aimed to identify the data using these bones in order to separate different bird species.

The present study aimed to define the anatomical structures by comparing the transversal computed tomography (CT) and magnetic resonance (MR) images of the forelimb joints of the rabbits with the cross‐sectional plastinated images. A total of 14 (seven females, seven males) one‐year‐old adult New Zealand rabbits were used in the study. After the CT and MR imaging procedures were completed, the forelimbs were removed from the body. The forelimbs were plastinated using the silicone plastination method and sectioned transversal. Cross‐sectional plastinates were evaluated and correlated anatomically with conjugate CT and MR images. Joint and surrounding anatomical structures were defined in sections. Cross‐sectional plastinated samples were highly correlated with CT and MR images in terms of bone and soft tissue, respectively. It is thought that the anatomical and radiological data obtained from the forelimb joints of rabbits will provide a basis for scientists who are involved in both experimental surgical interventions and clinical anatomy education.

In the field of anatomy, preservation techniques used to preserve the integrity of specimens prepared for use as educational and research material are very ancient. It is desirable that these materials be as close as possible to the characteristics of living animal tissues in order to be an effective educational material. One of the most important criteria in determining similarity to fresh cadavers is the color and odor changes in the tissues. Therefore, the aim of this study is to reveal the anatomical and physiological changes on myocardial tissue, fixed by 4 different solutions in which qualitative and quantitative methods such as color analysis, sensory analysis, and microbiological tests. As a result, it was determined that a newly developed enriched saline solution and low concentration formaldehyde solution can be used safely for the preparation, preserve and long term use of educational materials.