No abstract

Implantable drug delivery systems (IDDSs) offer good patient compliance and allow the controlled delivery of drugs over prolonged times. However, their application is limited due to the scarce material selection and the limited technological possibilities to achieve extended drug release. Porous structures are an alternative strategy that can overcome these shortcomings. The present work focuses on the development of porous IDDS based on hydrophilic (HPL) and hydrophobic (HPB) polyurethanes and chemical pore formers (PFs) manufactured by hot-melt extrusion. Different PF types and concentrations were investigated to gain a sound understanding in terms of extrudate density, porosity, compressive behavior, pore morphology and liquid uptake. Based on the rheological analyses, a stable extrusion process guaranteed porosities of up to 40% using NaHCO3 as PF. The average pore diameter was between 140 and 600 µm and was indirectly proportional to the concentration of PF. The liquid uptake of HPB was determined by the open pores, while for HPL both open and closed pores influenced the uptake. In summary, through the rational selection of the polymer type, the PF type and concentration, porous carrier systems can be produced continuously via extrusion, whose properties can be adapted to the respective application site.

No abstract

No abstract

Co-extrusion offers a number of advantages over conventional manufacturing techniques. However, the setup of a co-extrusion line is cost- and time-intense and formulation development is challenging. This work introduces a novel procedure to test the applicability of a co-extruded reservoir-type system at an early product development stage. We propose vacuum compression molding (VCM), a fast procedure that requires only small material amounts, for the manufacturing of cylindrical reservoir-type system. To this end, the commercially available co-extruded product NuvaRing and variations thereof were used as test systems. All VCM systems showed a homogeneous skin thickness that adhered well to the core, thereby providing a precise core/skin interface. As drug release is a key criterion for pharmaceutical products, a modified in vitro dissolution method was set up to test the VCM systems. The drug release from the VCM systems was in the same order of magnitude as the corresponding co-extruded strands and followed the same release kinetics. Moreover, the VCM systems were capable of indicating the relative effect of formulation-related modifications on drug release. Overall, this shows that this system is a powerful tool that facilitates formulation tailoring and co-extrusion process setup at the earliest stage.

No abstract

Reservoir systems (drug-loaded core surrounded by drug-free membrane) provide long-term controlled drug release. This is especially beneficial for drug delivery to specific body regions including the vagina. In this study, we investigated the potential of reservoir systems to provide high drug release rates over several weeks. The considered model system was an intra-vaginal ring (IVR) delivering progesterone (P4) in the mg/day range using ethylene-vinyl acetate (EVA) as release rate-controlling polymers. To circumvent the high material needs associated with IVR manufacturing, we implemented a small-scale screening procedure that predicts the drug release from IVRs. Formulations were designed based on the solubility and diffusivity of P4 in EVAs with varying vinyl acetate content. High in-vitro P4 release was achieved by (i) high P4 solubility in the core polymer; (ii) high P4 partition coefficient between the membrane and the core; and/or (iii) low membrane thicknesses. It was challenging for systems designed to release comparatively high fractions of P4 at early times to retain a constant drug release over a long time. P4 crystal dissolution in the core could not counterbalance drug diffusion through the membrane and drug crystal dissolution was found to be the rate-limiting step. Overall, high P4 release rates can be achieved from EVA-based reservoir systems

No abstract