No abstract

No abstract

Laser ablation inductively coupled plasma-mass spectrometry (ICP-MS) with (31)P detection has been used for spotting of phosphoproteins after one-dimensional polyacrylamide gel electrophoresis (1-D PAGE) and membrane transfer. By analyzing a mixture of myoglobin, alpha-casein and reduced fibrinogen it is demonstrated that phosphoproteins are specifically recognized by this method. A special washing step was found to be necessary to remove phosphate noncovalently bound to proteins. The (31)P signal was found to contain quantitative information both with respect to relative and absolute amounts of phosphorus present in phosphoproteins. Normalizing the (31)P signal from a single laser ablation trace by the total amount of phosphoprotein applied to the gel, a detection limit of 5 pmol of phosphorus is estimated.

In bacteria, the transcription of virulence genes is usually controlled by a cell density-dependent process known as "quorum sensing" (QS). QS relies on small diffusible signaling molecules that cross the bacterial cell wall and activate target transcription factors after a threshold concentration has been reached. Besides two hierarchical QS circuits based on N-acylhomoserine lactones, the human opportunistic pathogen Pseudomonas aeruginosa integrates a signaling system that depends on 2-heptyl-3-hydroxy-4-quinolone, termed "Pseudomonas quinolone signal" (PQS). PQS is produced from genes encoded in the pqs operon, which in addition to the biosynthetic enzymes PqsA-D contains a fifth gene, pqsE, that is not required for production of PQS but whose disruption leads to loss of signal transduction in several but not all pqs operon-dependent processes. PqsE was hence termed "PQS response protein", but its exact mechanism of action is unknown. We have determined the crystal structure of recombinant PqsE and show that it possesses a metallo-beta-lactamase fold with an Fe(II)Fe(III) center in the active site. A copurified ligand was assigned as benzoate and may indicate that PqsE exerts its regulatory effect by converting a chorismate-derived molecule. Further, PqsE was found to slowly hydrolyze phosphodiesters including single- and double-stranded DNA as well as mRNA and also the thioester S-(4-nitrobenzoyl)mercaptoethane. Higher activity was observed after incubation with Co(2+) and, to lesser entent, Mn(2+), suggesting that the Fe(II)Fe(III) center of recombinant PqsE may be an artifact of heterologous expression. A crystal complex of the E182A mutant with bis-pNPP was obtained and suggests a catalytic mechanism for hydrolysis.

Heavy metal concentrations were measured in airborne dust collected at three sites with different traffic densities from August 2001 to July 2002 in the Frankfurt am Main area. Bulk samples of particulate matter (PM) with an aerodynamic equivalent diameter of <22 microm were collected on cellulose nitrate filters using air filtration devices. Fractionated samples of PM with an aerodynamic equivalent diameter of <10 microm were collected using an eight-stage Andersen impactor. Pb, Cd, Mn, Ni, Zn, V, As, Sb, Cu, Cr, Co, and Ce were determined by inductively coupled plasma sector field mass spectrometry, Pt and Rh were determined by adsorptive voltammetry, and Pd was determined by total reflection X-ray fluorescence analysis. The results show that the highest airborne heavy metal concentrations occurred at the main street with a large volume of traffic. With the exception of Co, V, Ce, and Mn, the heavy metals had an elevated enrichment factor compared to their concentrations in the continental crust. The main street site was especially contaminated with Sb, Zn, Cu, V, and Ni. Motor vehicles are the likely source of emissions. With the exception of Cr, Cu, and Zn, most of the airborne heavy metal concentrations determined for impactor samples deviate slightly from the results for total airborne dust. Heavy metal particle size distributions can be divided into three groups. For metals such as As, Cd, Pb, and V, the main fraction can be found in fine particles with a diameter of <2.1 microm, whereas Ce, Cr, Co, and Ni occur mainly in coarse particles with a diameter of >2.1 microm. Cu, Mn, Sb, Zn, Pt, Pd, and Rh occur in high concentrations in the medium range of the impactor stages (particle diameters of 1.1-4.7 microm). Metal concentrations in fine dust particles are needed to assess the human health risks of their inhalation.

No abstract

No abstract

No abstract