The aim of this review was to summarize information and scientific data from the literature dedicated to the fate of polyacrylamide (PAM)-based flocculants in hydrosystems. Flocculants, usually composed of PAMs, are widely used in several industrial fields, particularly in minerals extraction, to enhance solid/liquid separation in water containing suspended matter. These polymers can contain residual monomer of acrylamide (AMD), which is known to be a toxic compound. This review focuses on the mechanisms of transfer and degradation, which can affect both PAM and residual AMD, with a special attention given to the potential release of AMD during PAM degradation. Due to the ability of PAM to adsorb onto mineral particles, its transport in surface water, groundwater, and soils is rather limited and restricted to specific conditions. PAM can also be a subject of biodegradation, photodegradation, and mechanical degradation, but most of the studies report slow degradation rates without AMD release. On the contrary, the adsorption of AMD onto particles is very low, which could favor its transfer in surface waters and groundwater. However, AMD transfer is likely to be limited by quick microbial degradation.

Polyacrylamides are polymers used in many fields and represent the main source of release of the highly toxic acrylamide in the environment. In this work, a simple, rapid, and sensitive analytical method was developed with HPLC/MS/MS and direct injection for acrylamide analysis in water and adsorption samples. AFNOR standards NF T90-210 and NF T90-220 were used for the analytical method validation and uncertainty estimation. Limit of quantification (LOQ) for acrylamide was 1 μg/L, and accuracy was checked at three acrylamide levels (1, 6, and 10 μg/L). Uncertainties were estimated at 34.2, 22, and 12.4 % for acrylamide concentrations at LOQ, 6 μg/L, and 10 μg/L, respectively. Acrylamide adsorption on clays (kaolinite, illite) and sludge was then studied as a function of pH, time, and acrylamide concentrations. Acrylamide adsorption on kaolinite, illite, and sludge was found to be very weak since adsorption percentages were inferior to 10 %, whatever the pH value and the initial acrylamide concentration. The low affinity of acrylamide for clays and sludge is likely due to its hydrophilic property, small size, and charge neutrality.