No abstract

No abstract

No abstract

No abstract

Because of wide applications of welded structures in different industries, using design codes and standards such as IIW recommendations is known as a safe and common method to design welded joints. The weld geometry and thickness of welded joint are the most important parameters that affect the fatigue strength of welded joints. In the present study, the fatigue behaviour of thin Al5456 butt‐welded joints has been investigated, and the effect of thickness on fatigue strength has been evaluated. Contrary to the above‐mentioned recommendations about thin welded joints, it was shown that the thickness of welded joints affects the fatigue strength. Moreover, the fatigue test results have been compared with the IIW design recommendations for three well‐known approaches in order to analyse the reliability of the codes. According to the design stress‐life diagrams, it was found that in some cases, the fatigue strength has much larger values than the IIW predictions, and IIW‐based design causes an over conservative design. While in some other cases, the fatigue strength is lower than IIW recommendations, and it leads to a non‐conservative design. Based on the experimental results, the new values for slope of S‐N curve and FAT have been proposed in order to improve the design diagrams.