In fertilizer-drawn forward osmosis (FDFO) desalination, the final nutrient concentration (nitrogen, phosphorus, potassium (NPK)) in the product water is essential for direct fertigation and to avoid over fertilization. Our study with 11 selected fertilizers indicate that blending of two or more single fertilizers as draw solution (DS) can achieve significantly lower nutrient concentration in the FDFO product water rather than using single fertilizer alone. For example, blending KCl and NH(4)H(2)PO(4) as DS can result in 0.61/1.35/1.70 g/L of N/P/K, which is comparatively lower than using them individually as DS. The nutrient composition and concentration in the final FDFO product water can also be adjusted by selecting low nutrient fertilizers containing complementary nutrients and in different ratios to produce prescription mixtures. However, blending fertilizers generally resulted in slightly reduced bulk osmotic pressure and water flux in comparison to the sum of the osmotic pressures and water fluxes of the two individual DSs as used alone. The performance ratio or PR (ratio of actual water flux to theoretical water flux) of blended fertilizer DS was observed to be between the PR of the two fertilizer solutions tested individually. In some cases, such as urea, blending also resulted in significant reduction in N nutrient loss by reverse diffusion in presence of other fertilizer species.

This study investigated the sustainable reuse of wastewater using fertilizer drawn forward osmosis (FDFO) process through osmotic dilution of commercial nutrient solution for hydroponics, a widely used technique for growing plants without soil. Results from the bench-scale experiments showed that the commercial hydroponic nutrient solution (i.e. solution containing water and essential nutrients) exhibited similar performance (i.e., water flux and reverse salt flux) to other inorganic draw solutions when treating synthetic wastewater. The use of hydroponic solution is highly advantageous since it provides all the required macro-(i.e., N, P and K) and micronutrients (i.e., Ca, Mg, S, Mn, B, Zn and Mo) in a single balanced solution and can therefore be used directly after dilution without the need to add any elements. After long-term operation (i.e. up to 75% water recovery), different physical cleaning methods were tested and results showed that hydraulic flushing can effectively restore up to 75% of the initial water flux while osmotic backwashing was able to restore the initial water flux by more than 95%; illustrating the low-fouling potential of the FDFO process. Pilot-scale studies demonstrated that the FDFO process is able to produce the required nutrient concentration and final water quality (i.e., pH and conductivity) suitable for hydroponic applications. Coupling FDFO with pressure assisted osmosis (PAO) in the later stages could help in saving operational costs (i.e., energy and membrane replacement costs). Finally, the test application of nutrient solution produced by the pilot FDFO process to hydroponic lettuce showed similar growth pattern as the control without any signs of nutrient deficiency.

Engineered nanomaterials (ENM) are manufactured, as opposed to being an incidental by-product of combustion or a natural process, and they often have unique or novel properties that emerge from their small size. These materials are being used in an expanding array of consumer products and, like all technological developments, have both benefits and risks. As the use of ENM in consumer products becomes more common, the amount of these nanomaterials entering wastewater stream increases. Estimates of nanomaterials production are in the range of 500 and 50,000 tons per year for silver and titanium dioxide (TiO 2 ) alone, respectively. Nanomaterials enter the wastewater stream during the production, usage, and disposal of nanomaterial-containing products. The predicted values of nanomaterials range from 0.003 (fullerenes) to 21 ng L −1 (nano-TiO 2 ) for surface waters, and from 4 ng L −1 (fullerenes) to 4 g L −1 (nano-TiO 2 ) for sewage treatment effluents. Therefore, investigating the fate of nanomaterials in wastewater streams is critical for risk assessment and pollution control. This review aims to firstly, identify the sources of nanomaterials reaching wastewater streams, then determine their occurrence and distribution, and finally discuss their fate in relation to human and ecological health, and environmental impact.

No abstract

In this study, Degussa P25 TiO2 was partially dissolved in a mixture of hydrogen peroxide and sodium hydroxide at high pH. The fabrication of nanofibres proceeded by the hydrothermal treatment of the solution at 80 °C. This was followed by acid wash in HCl at pH 2 for 60 min, which resulted in the formation of hydrogen-titanate nanofibres. The nanofibres were annealed at 550 °C for 6 h to produce crystalline anatase nanofibres. The nanofibres were characterised for physico-chemical modifications and tested for the adsorption and photocatalytic degradation of methylene blue as a model water pollutant. An average specific surface area of 31.54 m(2)/g, average pore volume of 0.10 cm(3)/g and average pore size of 50 Å were recorded. The nanofibres were effective adsorbents of the model pollutant and adsorbents and good photocatalysts under simulated solar light illumination. No reduction in photocatalytic activity was observed over three complete treatment cycles, and the effective separation of nanofibres was achieved by gravity settling resulting in low residual solution turbidity.

No abstract

No abstract

Flocculation with titanium tetrachloride (TiCl(4)) and titanium sulfate (Ti(SO(4))(2)) was investigated in terms of different coagulant doses, pH, turbidity, dissolved organic carbon (DOC), UV-254, colour, zeta potential, particle size and molecular weight distribution. The two coagulants were compared with the commonly used coagulants such as ferric chloride (FeCl(3)) and aluminium sulfate (Al(2)(SO(4))(3)). Titanium tetrachloride showed the highest turbidity removal, while titanium sulfate showed the highest reduction of UV-254 and colour at all pH values. The four coagulants were found to have similar organic removal up to 60-67% and resulted in similar organic removal in terms of various MW ranges. The decantability of the settled flocs was very high for titanium tetrachloride, titanium sulfate and ferric chloride compared with aluminium sulfate. The dominating coagulation mechanisms for titanium tetrachloride and titanium sulfate are still to be studied, since different precipitation reactions might take place at different pH even without flocculant addition. Titanium tetrachloride and titanium sulfate were found as effective new coagulants in wastewater treatment not only in terms of organic matter removal, but also in sludge reduction through the production of titanium dioxide.