Metabolic engineering often necessitates chromosomal integration of multiple genes but integration of large genes into Escherichia coli remains difficult. CRISPR/Cas9 is an RNA-guided system which enables site-specific induction of double strand break (DSB) and programmable genome editing. Here, we hypothesized that CRISPR/Cas9-triggered DSB could enhance homologous recombination and augment integration of large DNA into E. coli chromosome. We demonstrated that CRISPR/Cas9 system was able to trigger DSB in >98% of cells, leading to subsequent cell death, and identified that mutagenic SOS response played roles in the cell survival. By optimizing experimental conditions and combining the λ-Red proteins and linear dsDNA, CRISPR/Cas9-induced DSB enabled homologous recombination of the donor DNA and replacement of lacZ gene in the MG1655 strain at efficiencies up to 99%, and allowed high fidelity, scarless integration of 2.4, 3.9, 5.4, and 7.0 kb DNA at efficiencies approaching 91%, 92%, 71%, and 61%, respectively. The CRISPR/Cas9-assisted gene integration also functioned in different E. coli strains including BL21 (DE3) and W albeit at different efficiencies. Taken together, our methodology facilitated precise integration of dsDNA as large as 7 kb into E. coli with efficiencies exceeding 60%, thus significantly ameliorating the editing efficiency and overcoming the size limit of integration using the commonly adopted recombineering approach. Biotechnol. Bioeng. 2017;114: 172-183. © 2016 Wiley Periodicals, Inc.

Microalgae serve as a promising source for the production of biofuels and bio-based chemicals. They are superior to terrestrial plants as feedstock in many aspects and their biomass is naturally rich in lipids, carbohydrates, proteins, pigments, and other valuable compounds. Due to the relatively slow growth rate and high cultivation cost of microalgae, to screen efficient and robust microalgal strains as well as genetic modifications of the available strains for further improvement are of urgent demand in the development of microalgae-based biorefinery. In genetic engineering of microalgae, transformation and selection methods are the key steps to accomplish the target gene modification. However, determination of the preferable type and dosage of antibiotics used for transformant selection is usually time-consuming and microalgal-strain-dependent. Therefore, more powerful and efficient techniques should be developed to meet this need. In this review, the conventional and emerging genome-editing tools (e.g., CRISPR-Cas9, TALEN, and ZFN) used in editing the genomes of nuclear, mitochondria, and chloroplast of microalgae are thoroughly surveyed. Although all the techniques mentioned above demonstrate their abilities to perform gene editing and desired phenotype screening, there still need to overcome higher production cost and lower biomass productivity, to achieve efficient production of the desired products in microalgal biorefineries.

No abstract

No abstract

A three-dimensional (3-D) computational fluid dynamics model, coupled with population balance (CFD-PBM), was developed to describe the gas-solid two-phase flow in fluidized-bed polymerization reactors. The model considered the Eulerian-Eulerian two-fluid model, the kinetic theory of granular flow, the population balance, and heat exchange equations. First, the model was validated by comparing simulation results with the classical calculated data. The entire temperature fields in the reactor were also obtained numerically. Furthermore, two case studies, involving constant solid particle size and constant polymerization heat or evolving particle-size distribution, polymerization kinetics, and polymerization heat, were designed to identify the model. The results showed that the calculated results in the second case were in good agreement with the reality. Finally, the model of the second case was used to investigate the influences of operational conditions on the temperature field.

No abstract

No abstract

A thermophilic Geobacillus bacterium secreting high activity of endo-glucanase (EC 3.2.1.4) was isolated from rice straw compost supplemented with pig manure. A full-length gene of 1,104 bp, celA, encoding this glycosyl hydrolase family 5 endo-glucanase of 368 amino acids was isolated. No related gene from Geobacillus has been reported previously. The recombinant CelA expressed in Escherichia coli had an optimal activity at 65 degrees C and pH 5.0, and it exhibited tenfold greater specific activity than the commercially available Trichoderma reesei endo-glucanase. CelA displayed activity over a broad temperature range from 45 to 75 degrees C and was a thermostable enzyme with 90% activity retained after heating at 65 degrees C for 6 h. Interestingly, CelA activity could be enhanced by 100% in the presence of 2 mM MnSO(4). CelA had high specific activity over beta-D-glucan from barley and Lichenan, making it a potentially useful enzyme in biofuel and food industries.