No abstract

Abstract-The influence of a load resistor on the shape of the single event transients was investigated in the LM124 operational amplifier by means of laser tests. These experiments indicated that, as a general rule, load resistors modify the size of the transients. SPICE simulations helped to understand the reasons of this behavior and showed that the distortion is related to the necessity of providing or absorbing current from the load resistor, which forces the amplifier to modify its operation point. Finally, load effects were successfully used to explain the distortion of single event transients in typical feed-back networks and the results were used to explain experimental data reported elsewhere.

Abstract-The peak detector effect is a phenomenon that makes single event transients much longer once an error amplifier switches from linear to saturation zone due to the presence of external capacitors. This is so-called since it was discovered in a simple voltage reference in which a parasitic lossy peak detector was unwillingly built in the output stage. In this paper, peak detector effect is generalized to explain the appearance of long duration pulses in typical low dropout voltage regulator built with discrete devices. This effect has been related to the way in which the negative feedback loop is closed and to the kind of pass device in the output stage. Thus, if the linear voltage regulator consists in an error amplifier the output of which controls a current source, the peak detector effect will occur if the current source is unidirectional, the output load does not drain enough current and is in parallel with an external capacitor.

Abstract-One of the main phenomena that commit the reliability of analog electronic systems working in the outer space is the presence of energetic ions that produce spurious transients after crossing the device. These pulses are transmitted to the network loading the device and can eventually lead to dangerous situations as it has been observed in some spatial missions. This paper shows how the value of the resistor loading the device can affect the shape of the transients.