No abstract

The time evolution of dielectric barrier discharge driven by nanosecond pulse high-voltage power is investigated by high-speed video analysis, electrical measurements and spectral diagnostics. It is found that the discharge mode generally goes through the evolution process of filamentary discharge → diffuse discharge → filamentary discharge with the increase in discharge cycle. The time-dependent changes in the standard deviation of image gray levels indicate that the discharge uniformity first improves and then deteriorates in this evolution process. The different pre-ionization density and modulated distribution of space charges and surface charges are considered to be the main reasons for the time evolution of discharge uniformity. In addition, the experiments under different frequencies and voltages show that the transition of the discharge mode is more likely to occur at higher frequency and higher voltage. Further measurement and calculation reveal that the discharge at high frequency and high voltage has the same characteristics, that is, high pre-ionization degree, thick filament diameter and short time lag. These characteristics usually lead to higher seed electron density, larger critical avalanche size and weaker lateral inhibition effect, which make the discharge mode transition more likely to occur.

Coalescence of conducting droplets dispersed in an immiscible medium can be facilitated by an electric field. However, droplets recoil promptly after contact in sufficiently high electric fields if the cone angle between droplets exceeds a critical value. To elucidate the critical condition for droplet coalescence, the behavior of two suspended droplets after contact with a direct current electric field is studied. It is shown that the critical angle is determined not only by the droplet geometry but also conductivity, surfactant concentration, and size. As the droplet conductivity increases, more identical ions accumulate on the adjacent interfaces of two droplets due to the faster ionic migration, which results in Coulombic repulsion between droplets and a reduced critical angle. For surfactant-laden droplets, film drainage induces a surfactant concentration gradient on the leading edges of droplets, and then Marangoni stress is formed to reduce the critical angle. In the case of large droplets, the bridge transiently expands under the action of directional flow caused by further droplet deformation, but eventually breaks due to opposite electrostatic forces. Based on this finding, the electrocoalescence criterion can be determined and employed to facilitate droplet coalescence in various applications.

No abstract

The current understanding and developments of phase separation technology based on ultrasonic standing waves (USWs) are reviewed. Most previous reviews have focused on microscale applications of this technology in the fields of biological materials and food processing. This review covers different applications of ultrasonic separation technology, especially in petrochemical industry. The kinetic mechanism of ultrasonic, design of reactors, separation principles, and related applications are discussed in detail. We lay special stress on the motion characteristics of particles in USWs. According to the particle numbers, particle properties, and frequency characteristics, the separation principles are reasonably categorized as: (1) Bands effect; (2) Acoustophoretic coefficient; (3) Particle density; (4) Sweep frequency. Diverse separation principles improve the universality of ultrasonic separation technology. However, acoustic streaming and acoustic cavitation are two of the main challenges in the application of ultrasonic separation. Based on the current research, the future research can focus on the following aspects: (1) Explore the mechanism of ultrasonic demulsification; (2) Establish unified evaluation criteria for acoustic separation systems; (3) Develop the basis for determination of acoustic cavitation and non-cavitation.

A magnetic field, with the direction parallel to the electric field, is applied to the repetitively unipolar positive nanosecond pulsed dielectric barrier discharge. The effect of the parallel magnetic field on the plasma generated between two parallel-plate electrodes in quiescent air is experimentally studied under different pulse repetition frequencies (PRFs). It is indicated that only the current pulse in the rising front of the voltage pulse occurs, and the value of the current is increased by the parallel magnetic field under different PRFs. The discharge uniformity is improved with the decrease in PRF, and this phenomenon is also observed in the discharge with the parallel magnetic field. By using the line-ratio technique of optical emission spectra, it is found that the average electron density and electron temperature under the considered PRFs are both increased when the parallel magnetic field is applied. The incremental degree of average electron density is basically the same under the considered PRFs, while the incremental degree of electron temperature under the higher-PRFs is larger than that under the lower-PRFs. All the above phenomena are explained by the effect of parallel magnetic field on diffusion and dissipation of electrons.

In this paper, the conical breakup of a water droplet suspended in oil under the alternating current (ac) electric field was experimentally studied with the help of a high-speed video camera. We observed three stages of transient oscillation of deformation characterized by deformation degree l* before the conical breakup that were described in detail. Then a theoretical model was developed to find out the dynamic mechanisms of that behavior. Despite a very small discrepancy, good agreement between model predictions and experimental observations of the evolution of the droplet deformation was observed, and the possible reasons for the discrepancy were discussed as well. Finally, the stresses on the interface were calculated with the theoretical model and their influence on the dynamic behavior before the breakup was obtained. The differences between the droplet breakup mode of ac and direct current electric field are also discussed in our paper.

No abstract