BackgroundThe gonial angle is one of the most important measurements required for orthodontic treatment and orthognathic surgery. It is difficult to determine the accurate measurement of each gonial angle on cephalometric radiographs because of superimposition of the left and right angles.ObjectivesThe aim of the present study was to determine the right and left gonial angles on panoramic radiographs and to compare them with an evaluated cephalometric sample.Patients and MethodsA total of 80 panoramic and 80 cephalometric radiographs were obtained from 6 to 12-year-old children and the gonial angle was determined by the tangent of the inferior border of the mandible and the most distal aspect of the ascending ramus and the condyleon both panoramic and cephalometric radiographs. We used Pearson’s correlation coefficient and paired t-test for comparison.ResultsThe mean gonial angle was 127.07 ± 6.10 and 127.5 ± 6.67 degrees on panoramic and cephalometric radiographs, respectively. There was no statistically significant difference between the measured gonial angles on panoramic and cephalometric radiographs and also no difference between the right and left (both Ps = 0.18)ConclusionThe value of the gonial angle measured on panoramic radiography was the same as that measured on the routinely used cephalometric radiography.

The aim of the study was to determine the rela-tionship between Body Mass Index (BMI) and accelerated dental development. The dental developmental ages of 100 children aged between 8 and 12 years were determined using the Demirjian method and panoramic radiographs. BMI status was determined for each subject on the basis of the system developed by the International Obesity Task Force. There was a significant direct relationship between dental development and BMI (P < 0.01). Obese children have a higher rate of dental development compared to normal children. CLINICAL RELEVANCE: This is an important variable to be considered when planning for dental and orthodontic treatments in obese children. Brief objectives statement: Overweight or obesity can accelerate dental development. Accelerated dental development in overweight children is important to be considered in pediatric dentistry and orthodontics

Background:The aim of this study was to evaluate the hypothesis that budesonide increases the susceptibility of teeth to root resorption during the course of orthodontic treatment.Materials and Methods:A randomized controlled trial design (animal study) was employed. Budesonide was administered in test group for 14 days during which orthodontic force was applied to upper right molar. Afterwards, root resorption was measured on mesio-cervical and disto-apical parts of the mesial root on transverse histological sections. ANOVA and Bonfferoni tests were used. Statistical significance was considered to be P ≤ 0.05.Results:In general, the subgroups in which the force was applied showed significantly greater root resorption. Where force was applied there was no significant difference, whether budesonide was administered or not. While where there was no force, a group who received budesonide showed significantly greater root resorption than the other, unless at the coronal level where the difference was not significant.Conclusion:Within the limitations of this study, it seems budesonide could increase root resorption, but in the presence of orthodontic force this effect is negligible.

Background: laser aided debonding of ceramic brackets has been proved to be effective in reducing enamel surface damages, though the optimal parameters of laser to be chose is in question. The aim of this study was to investigate the six different regimens of diode laser irradiation on enamel surface characteristics and intrapulpal temperature changes while debonding. Material and Methods: 90 polycrystalline brackets were bonded to 90 intact extracted premolars. At debonding, teeth were divided into 6 groups (n = 15) and were subjected to the following regimen of diode laser irradiation; G1 = 2 W, continuous wave, G2 = 2.5 W, continuous wave, G3 = 3 W, continuous wave, G4 = 2 W, pulsed mode, G5 = 2.5 W, pulsed mode, G6 = 3 W, pulsed mode. After debonding, the adhesive remnant index, the lengths and frequency of enamel cracks were compared among the groups. 5 teeth out of 15 were randomly selected from each group to assess the intrapulpal temperature changes. Results: The number of enamel cracks increased significantly in all the specimens after debonding. Enamel crack length increased significantly in all the study groups except G3 and G6. The increase in intrapulpal temperature was significantly below the benchmark of 5.5 C for all the specimens. Significant difference was observed in adhesive remnant index scores among the groups and more than half of the teeth showed a score of 2. Conclusion: Diode-laser irradiation in pulsed mode or continuous wave at given outputs (2, 2.5, 3 W) were not statistically different in regard to producing enamel surface damages or increasing intrapulpal temperature.