ABSTRACT:The kinetics of curing reaction of a diglycidyl ether of a bisphenol-A based epoxy (DGEBA) with 4,4Ј-diaminostillbene (DAS) and 4,4Ј-diaminoazobenzene (DAAB) as curing agents are studied by differential scanning calorimetery (DSC) using the isothermal technique. The experimental data show that the cure reaction is autocatalytic in nature, and all kinetic parameters of the curing reaction are determined using a semiempirical equation. The reaction of DGEBA with DAS is faster than that with DAAB under the same conditions and the activation energies of both systems are higher than those reported for other aromatic diamines. With increasing isothermal temperature and concentration of curing agents the rate constants are increased by the increasing of probability collisions between epoxide and primary amine groups while the activation energies remain constant.

No abstract

No abstract

No abstract

Multiwall carbon nanotubes were functionalized with epoxy groups by chemical modification in four stages. At each stage, the compound was characterized by Fourier transform infrared spectroscopy and scanning electron microscopy (SEM). Epoxy composite samples were prepared by mixing diglycidyl ether of bisphenol A‐based epoxy resin and synthetic epoxy‐functionalized multiwall carbon nanotube (E‐MWCNT) with different percentages (1, 3, 6, 9, 12, and 15%) in acetone. Ultrasonic dispersion was used to produce homogenous blends. The optimum ratio of the reacting components (9%) was investigated by total enthalpy of the curing reaction from differential scanning calorimetry (DSC) thermograms. The kinetics of the curing reaction for epoxy composites with 4,4′‐diaminodiphenylsolfon as a curing agent was studied by means of a DSC nonisothermal technique. The kinetic parameters such as activation energy, pre‐exponential factor, and rate constant were obtained from DSC data. The structure ofthe nanocomposites and dispersion of the E‐MWCNTs in the nanocomposites were observed using SEM, and the thermal properties were studied by thermogravimetric analysis. POLYM. COMPOS., 2012. © 2012 Society of Plastics Engineers