on the specimenswhich are madeby self-propagating high-temperature synthesis (SHS) using three kinds of titanium raw powder. Chlorine as an impurity was found to enhancethe formation of porosities, resulting in degrading the mechanical properties, especially the tensile strength.
Fracture surface observations were enforced after cyclic bending fatigue test, three point bending test and impact test. It was confirmed that striation pattern, dimple pattern and cleavage was formed on each fracture surfaces. These patterns corresponded with each failure modes. Pearlite phase was only observed on fatigue fracture surface. These obtained data will be applicable to compare to the fracture surface, when the machine part made in gray cast iron was damaged. Because the crack occurred on gray cast iron is apt to propagate along it due to stress concentration and stress intensity factor increase in the graphite, that is why if some pattern was formed on the fracture surface of machine part, but it is difficult to judge whether actual failure mode is suggested due to its pattern or not.Key words: Gray cast iron, Fracture surface, Microscopic appearance, Matrix, Failure mode, Cleavage, Striation pattern, Dimple pattern, Pearlite phase
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.