An experimental investigation to improve the stage efficiency through the use of vaned diffusers is presented. Sixteen different vaned diffusers were tested on a model compressor rig. The results showed that the pressure recovery of the vaned diffuser increased up to the critical diffusion ratio, which was shown to be approximately 0.5. The measured pressure distribution around vanes of the well-designed diffusers which had the fair diffusion ratios, were found to agree well with the potential flow solutions. Finally, the importance of the diffuser inlet configuration to the improvement of the stage efficiency is discussed.
This paper describes the optimal design and experimental verification of centrifugal compressors with leaned curvilinear element blades. The design targets were a fully shrouded centrifugal impeller and a low-solidity vaned diffuser.
First, a new method of defining the curvilinear element blade was developed for centrifugal turbomachinery using coordinate transformations between a revolutionary flow-surface coordinate system and a cylindrical coordinate system. All the blade sections in the transferred cylindrical coordinate system were moved and stacked spanwise to form a new leaned blade surface. The inverse transformation results in a curvilinear element blade in the original coordinate system. The direction of movement of the blade section could be any of the existing definitions such as sweep, dihedral, or tangential lean. For simplicity, we have defined a “lean profile” as a general expression for the spanwise distribution profile of movement of the blade sections.
Model compressors with curvilinear element blades were then designed at a suction flow coefficient of 0.073. Optimal lean profiles for the impeller and vaned diffuser that maximized adiabatic efficiency and uniformity of outflow were explored using a multi-objective genetic algorithm, Kriging surrogate model, and steady Reynolds-averaged Navier Stokes simulations. We chose efficiency-weighted solutions since the efficiency and uniformity had a positive correlation. A sensitivity analysis showed that tangential leans near the endwalls are keys for improving the impeller’s efficiency. The chosen optimal impeller had a concave blade suction surface and a concave leading edge. Although clear patterns in geometrical features for optimal diffuser vanes could not be captured, we found that the dihedral profile had a predominant effect on efficiency.
The model compressors was experimentally measured and compared with traditional compressors as to their aerodynamic performance. The experimental apparatus was composed of a suction nozzle, impeller, diffuser, and return channel. The results demonstrated that the models’ adiabatic efficiency was higher by 1.2–1.4% at the design point. Although the stall margins slightly decreased (by 0.7%) in the experiments, the surge margins expanded (by 3.7–6.7%).
Performance improvement of 3D impellers in a high specific speed range was investigated using computational fluid dynamics analyses and experimental tests. In order to reduce the loss production within the stator passages, the backsweep angle of the impellers was increased. At the same time, the inlet-to-exit relative velocity diffusion ratio was also increased by increasing the impeller exit width to prevent the reduction in the pressure ratio. Moreover, the blade loading distribution at the impeller shroud side was optimized to suppress the surge margin reduction caused by the increased relative velocity diffusion ratio. Five types of unshrouded impellers were designed, manufactured, and tested to evaluate the effects of blade loading, backsweep angle, and relative velocity diffusion ratio on the compressor performance. The design suction flow coefficient was 0.125 and the machine Mach number was 0.87. Test results showed that the compressor stage efficiency was increased by 5% compared with the base design without reducing the pressure coefficient and surge margin. It was concluded that an increased relative velocity diffusion ratio coupled with large backsweep angle was a very effective way to improve the compressor stage efficiency. An appropriate blade loading distribution was also important in order to achieve a wide operating range as well as high efficiency.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.