A bipolar membrane (BPM) can be used to accelerate water dissociation to maintain a pH gradient in electrochemical cells, providing freedom to independently optimize the environments and catalysts used for paired reduction and oxidation reactions. The two physical layers in a BPM, respectively, selective for the exchange of cations and anions, should ideally reject ion crossover and facilitate ionic current via water dissociation in an interfacial layer. However, ions from the electrolyte do cross over in actual BPMs, competing with the water dissociation reaction and negatively affecting the stability of the electrolytes. Here, we explore the mechanisms of ion crossover as a function of pH and current density across a commercial BPM. Our unique series of experiments quantifies the ion crossover for more than 10 electrolyte combinations that cover 10 orders of magnitude in acid dissociation constant (K a ) and current densities spanning over more than 2 orders of magnitude. It was found that the ion crossover is dominated by diffusion for current densities up to a maximum of 10−40 mA cm −2 depending on the electrolyte, while migration is of higher importance at high current densities. The influence of the electrolyte pK a or pH on the ion crossover is not straightforward. However, ions with a higher valence or ion size show significantly lower crossover. Moreover, high current densities are the most favorable for high water dissociation efficiencies for all electrolyte combinations. This operational mode aligns well with practical applications of BPMs in electrolysis at industrial relevant current densities.
Rice poses a major source of the toxic contaminant cadmium (Cd) for humans. Here, we elucidated the role of Cd storage forms (i.e., the chemical Cd speciation) on the dynamics of Cd within rice. In a pot trial, we grew rice on a Cd-contaminated soil in upland conditions and sampled roots and shoots parts at flowering and maturity. Cd concentrations, isotope ratios, Cd speciation (X-ray absorption spectroscopy), and micronutrient concentrations were analyzed. During grain filling, Cd and preferentially light Cd isotopes were strongly retained in roots where the Cd storage form did not change (Cd bound to thiols, Cd–S = 100%). In the same period, no net change of Cd mass occurred in roots and shoots, and the shoots became enriched in heavy isotopes (Δ114/110Cdmaturity–flowering = 0.14 ± 0.04‰). These results are consistent with a sequestration of Cd in root vacuoles that includes strong binding of Cd to thiol containing ligands that favor light isotopes, with a small fraction of Cd strongly enriched in heavy isotopes being transferred to shoots during grain filling. The Cd speciation in the shoots changed from predominantly Cd–S (72%) to Cd bound to O ligands (Cd–O, 80%) during grain filling. Cd–O may represent Cd binding to organic acids in vacuoles and/or binding to cell walls in the apoplast. Despite this change of ligands, which was attributed to plant senescence, Cd was largely immobile in the shoots since only 0.77% of Cd in the shoots were transferred into the grains. Thus, both storage forms (Cd–S and Cd–O) contributed to the retention of Cd in the straw. Cd was mainly bound to S in nodes I and grains (Cd–S > 84%), and these organs were strongly enriched in heavy isotopes compared to straw (Δ114/110Cdgrains/nodes–straw = 0.66–0.72‰) and flag leaves (Δ114/110Cdgrains/nodes–flag leaves = 0.49–0.52‰). Hence, xylem to phloem transfer in the node favors heavy isotopes, and the Cd–S form may persist during the transfer of Cd from node to grain. This study highlights the importance of Cd storage forms during its journey to grain and potentially into the food chain.
Cadmium concentrations in cacao (Theobroma cacao L.) beans from South America often exceed trade limits. Liming soil is advocated as a remediation option, but amendments cannot be incorporated into the entire root zone without harming the trees. An experiment was set up to identify how Cd uptake varies within the root zone when surface and subsurface soil layers are either limed or not. The experiment used 22-cm-height pots with top and bottom layers using surface and subsurface soil samples from a cacao field. The potted soils were either surface limed or not or fully limed and layers spiked with stable 108 Cd isotope in various combinations to trace the plant Cd provenance. The root distribution was neither affected by liming nor by soil source; 70% of the root biomass was present in the top layer. Plants grown on the fully limed surface soil had 1.7 times lower Cd concentrations in leaves than the unlimed treatments, whereas this concentration was 1.2 times lower when only the top layer was limed (surface soil used in both layers). The isotope dilution data showed that surface soil liming enhanced Cd uptake from the unlimed bottom layer compared with the unlimed soil, suggesting compensating mechanisms. The pots containing surface soil over subsurface soil also showed that compensating effect but, due to lower phytoavailable Cd in the subsurface soil, surface liming still effectively reduced foliar Cd. We conclude that liming might be a feasible mitigation strategy, but its effectiveness is limited when Cd phytoavailability remains untreated in the subsurface layer.
The research on strategies to reduce cadmium (Cd) accumulation in cacao beans is currently limited by a lack of understanding of the Cd transfer pathways within the cacao tree. Here, we elucidated the transfer of Cd from soil to the nib (seed) in a high Cd accumulating cacao cultivar. Here, we elucidated the transfer of Cd from soil to the nib (seed) in a high Cd accumulating cacao cultivar through Cd stable isotope fractionation, speciation (X-Ray Absorption Spectroscopy), and localization (Laser Ablation Inductively Coupled Plasma Mass Spectrometry). The plant Cd concentrations were 10-28 higher than the topsoil Cd concentrations and increased as placenta< nib< testa< pod husk< root< leaf< branch. The retention of Cd in the roots was low. Light Cd isotopes were retained in the roots whilst heavier Cd isotopes were transported to the shoots (Δ 114/110 Cd shoot-root = 0.27 ± 0.02 ‰ (weighted average ± standard deviation)). Leaf Cd isotopes were heavier than Cd in the branches (Δ 114/110 Cd IF3 leaves-branch = 0.18 ± 0.01 ‰), confirming typical trends observed in annual crops. Nibs and branches were statistically not distinguishable (Δ 114/110 Cd nib-branch = −0.08‰ ± 0.06 ‰), contrary to the leaves and nibs (Δ 114/110 Cd nib-IF3 leaves = -0.25‰ ± 0.05 ‰). These isotope fractionation patterns alluded to a more direct transfer from branches to nibs rather than from leaves to nibs. The largest fraction (57%) of total plant Cd was present in the branches where it was primarily bound to carboxyl-ligands (60-100%) and mainly localized in the phloem rays and phelloderm of the bark. Cadmium in the nibs was mainly bound to oxygen ligands (60-90%), with phytate as the most plausible ligand. The weight of evidence suggested that Cd was transferred like other nutrients from root to shoot and accumulated in the phloem rays and phelloderm of the branches to reduce the transfer to foliage. Finally, the data indicated that the main contribution of nib Cd was from the phloem tissues of the branch rather than from leaf remobilization. This study extended the limited knowledge on Cd accumulation in perennial, woody crops and revealed that the Cd pathways in cacao are markedly different than in annual crops.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.