Hot-film measurements in a fully developed channel flow have been made in an attempt to gain more insight into the process of Reynolds stress production. The background for this effort is the observation of a certain sequence of events (deceleration, ejection and sweep) in the wall region of turbulent flows by Corino (1965) and Corino & Brodkey (1969). The instantaneous product signal uv was classified according to the sign of its components u and v, and these classified portions were then averaged to obtain their contributions to the Reynolds stress $-\rho\overline{uv} $. The signal was classified into four categories; the two main ones were that with u negative and v positive, which can be associated with the ejection-type motion of Corino & Brodkey (1969), and that with u positive and v negative, associated with the sweep-type motion. It was found that over the wall region investigated, 3·5 [les ] y [les ] 100, these two types of motion give rise to a stress considerably greater than the total Reynolds stress. Two other types of motion, (i) u negative, v negative, corresponding to low-speed fluid deflected towards the wall, and (ii) u positive, v positive, corresponding to high-speed fluid reflected outwards from the wall, were found to account for the ‘excess’ stress produced by the first two categories, which give contributions of opposite sign.The autocorrelations of the classified portions of uv were obtained to determine the relative time scales of these four types of motion. The positive stress producing motions (u < 0, v > 0 and u > 0, v < 0) were found to have significantly larger time scales than the negative stress producing motions (u < 0, v < 0 and u > 0, v > 0). It was further surmised that turbulent energy dissipation is associated with the Reynolds stress producing motions, since these result in localized shear regions in which the dissipation is several orders of magnitude greater than the average dissipation at the wall.

The transition of the cylinder wake is investigated experimentally in a water channel and is computed numerically using a finite-difference scheme. Four physically different instabilities are observed: a local "vortex-adhesion mode," and three near-wake instabilities, which are associated with three different spanwise wavelengths of approximately 1, 2, and 4 diam. All four instability processes can originate in a narrow Reynolds-number interval between 160 and 230, and may give rise to different transition scenarios. Thus, Williamson's [Phys. Fluids 31, 3165 (1988)] experimental observation of a hard transition is for the first time numerically reproduced, and is found to be induced by the vortex-adhesion mode. Without vortex-adhesion, a soft onset of three-dimensionality is numerically and experimentally obtained. A control-wire technique is proposed, which suppresses transition up to a Reynolds number of 230.

The fluctuating wall-shear stress was measured with various types of hot-wire and hot-film sensors in turbulent boundary-layer and channel flows. The rms level of the streamwise wall-shear stress fluctuations was found to be 40% of the mean value, which was substantiated by measurements of the streamwise velocity fluctuations in the viscous sublayer. Heat transfer to the fluid via the probe substrate was found to give significant differences between the static and dynamic response for standard flush-mounted hot-film probes with air or oil as the flow medium, whereas measurements in water were shown to be essentially unaffected by this problem.

Hot-film anemometer measurements have been carried out in a fully developed turbulent channel flow. An oil channel with a thick viscous sublayer was used, which permitted measurements very close to the wall. In the viscous sublayer between y+ ≃ 0·1 and y+ = 5, the streamwise velocity fluctuations decreased at a higher rate than the mean velocity; in the region y+ [lsim ] 0·1, these fluctuations vanished at the same rate as the mean velocity.The streamwise velocity fluctuations u observed in the viscous sublayer and the fluctuations (∂u/∂y)0 of the gradient at the wall were almost identical in form, but the fluctuations of the gradient at the wall were found to lag behind the velocity fluctuations with a lag time proportional to the distance from the wall. Probability density distributions of the streamwise velocity fluctuations were measured. Furthermore, measurements of the skewness and flatness factors made by Kreplin (1973) in the same flow channel are discussed. Measurements of the normal velocity fluctuations v at the wall and of the instantaneous Reynolds stress −ρuv were also made. Periods of quiescence in the − ρuv signal were observed in the viscous sublayer as well as very active periods where ratios of peak to mean values as high as 30:1 occurred.

A coupled Landau model describing the Strouhal-Reynolds number profile of a three-dimensional circular cylinder wake Phys. Fluids 15, L68 (2003);

Measurements of the three fluctuating components of the velocity and of the two components of the wall shear stress fluctuations have been made in a fully developed turbulent channel flow at Re=7700 using hot-film probes. These measurements include rms values, skewness and flatness factors, and probability density functions. Although the wall region is emphasized here, information for the whole channel half-width is also given.

The streamwise and spanwise velocity components and the gradients of these components normal to the wall were examined by using hot-film sensors and flush-mounted wall elements to study the vortex structures associated with the bursting phenomenon. Quadrant probability analysis and conditional sampling techniques indicated that pairs of counter-rotating streamwise vortices occur frequently in the wall region of a bounded turbulent shear flow. A streamwise momentum defect occurred between the vortices as low-speed fluid was ‘pumped’ away from the wall by the vortex pair. The defect region was long and narrow and possibly forms the low-speed streak as observed in visualization studies. The velocity defect was terminated by a strong acceleration followed by a high speed region.

A global, three-dimensional stability analysis of the steady and the periodic cylinder wake is carried out employing a low-dimensional Galerkin method. The steady flow is found to be asymptotically stable with respect to all perturbations for Re < 54. The onset of periodicity is confirmed to be a supercritical Hopf bifurcation which can be modelled by the Landau equations. The periodic solution is observed to be only neutrally stable for 54 < Re < 170. While two-dimensional perturbations of the vortex street rapidly decay, three-dimensional perturbations with long spanwise wavelengths neither grow nor decay. The periodic solution becomes unstable at Re = 170 by a perturbation with the spanwise wavelength of 1.8 diameters. This instability is shown to be a supercritical Hopf bifurcation in the spanwise coordinate and leads to a three-dimensional periodic flow. Finally the transition scenario for higher Reynolds numbers is discussed.