A new species of Chrysaora is described from five specimens collected off Turkey in the Eastern Mediterranean Sea during December 2018. The species is characterised by its pale exumbrella, milky to creamy in colour, bearing faint and narrow markings, strap-like marginal tentacles, semi-rounded to tongue-shaped lappets, and a prominent dark spot on the exumbrella above each rhopalium. Analysis of the COI gene indicates that it may be most closely related to Chrysaora africana (Vanhöffen 1902), from which it is nevertheless 10.2 % different. It is unclear whether the species represents a previously undetected and endemic species from the Mediterranean, or whether source populations are located in the Red Sea and the northern Indian Ocean.
The infestation rates observed and the evaluation of the questionnaire showed that there is a statistically significant relationships between pediculosis capitis and sex, level of family income, education level of the mother, number of baths taken per weekly, number of family members living in the same home, room number per capita, and hair length (p<0.001). However, there was no significant relationship between pediculosis capitis and cleaning materials used to wash the head (p>0.05).
This paper focuses on a design analysis of a flat die used in an agricultural biomass pelletizing machine by considering its high pressure loading failure susceptibility. The pellet die is one of the key elements in a pelletizing machine, and the strength of the die plate has an important role on the pellet's quality and producibility. In fact, higher compression ratio (CR-the ratio of effective length and the internal (press channel) diameter of a die orifice/hole) will provide denser pellets which is a desired phenomenon, however, if the compression pressure is too high or CR is not determined to compensate high pressures, the raw material may block the die and the die may experience deformation failure due to overloading. If the desire is to make high quality pellets with no die failure, optimum flat die hole/orifice design parameters should be used which can provide the best CR for a specific compression pressure. This is the core motivation of this research. In this study, Finite Element Analysis (FEA) based design exploration has been utilised for a sample single hole flat die with various die geometry parameters against various compression pressure values. Following the FEA design exploration undertaken, a response surface analysis (RSA) was carried out and then estimation models (empirical equations), which could be used to calculate parameters of the die hole/orifice against applied compression pressure and failure susceptibility based on structural stress and deformation, was described. The results gained from the RSA has indicated that the estimation models have high R 2 values (higher than 98 %) which could be used for adequately predicting failure susceptibility indicators. In addition to this, FEM-based simulation print-outs have provided useful stress distribution visuals on the die against different compression pressure values. Most especially, the study has highlighted that a detailed structural optimisation study may be scheduled in order to obtain die geometry design parameters with a focus on the failure susceptibility.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.