Driven by global warming, a relentless march towards increased fuel efficiency has resulted in increased firing temperature for HA-class engines without an increase in baseload emissions. Moreover, emissions compliance for CO, NOx, and unburned hydrocarbons are desired over increased range in gas turbine load. In addition, exceptional gas turbine operational flexibility is desired to address potential intermittency due to the penetration of renewables in the electrical grid.
Staged/sequential combustion is a state of the technology to provide operational flexibility and reduced emissions in power generation gas turbines. GE Power’s 7HA-class gas turbine combustion system combines GE’s proven DLN-2.6+ combustion technology, that has run reliably for over 1.3 million fired hours across more than eighty 9FA.03, 9F.05 & 7FA gas turbine engines, with an axially fuel staged system (AFS). Axially staging combustion to two zones allows for increased firing temperature at baseload (while maintaining the same NOx level) by operating the later/second stage hotter than the first/primary stage. During low load operation as the gas turbine firing temperature is reduced, percentage fuel split in the staged fuel system can either be reduced significantly or turned off and thereby keeping the overall combustion system into emissions compliance over a wider range of firing temperatures.
This paper presents both the development testing of the staged combustion in the FA and HA class gas turbine combustion system rigs at GE Power’s Gas Turbine Technology Laboratory and the validation testing of staged combustion system for the 7HA.01 engine completed during Spring 2016 at GE Power’s engine test facility in Greenville, SC. The paper also discusses the significant simplification of operational principle and flexibility of startup, loading and baseload operation of the 7HA combustion system. Discussion of engine test results will show how axial fuel staging was utilized to demonstrate emissions compliance ( NOx (15% O2) < 25 ppm; CO < 9 ppm), operation from 14% load to 100% load with low combustion dynamics and also to enable wide wobbe capability, which is a normalized measure of fuel flexibility.
A new rich-catalytic lean-burn combustion concept (trademarked by PCI as RCL) was tested at industrial gas turbine conditions, in Solar Turbines’ high-pressure (17 atm) combustion rig and in a modified Solar Turbines engine, demonstrating ultralow emissions of NOx<2 ppm and CO<10 ppm for natural gas fuel. For the single-injector rig tests, an RCL catalytic reactor replaced a single swirler/injector. NOx<3 ppm and CO<10 ppm were achieved over a 110°C operating range in flame temperature, including NOx<1 ppm at about 1350°C flame temperature. Combustion noise was less than 0.15% peak to peak. Four RCL catalytic reactors were then installed in a modified (single can combustor) engine. NOx emissions averaged 2.1 ppm over the allowable operating range for this modified engine, with CO<10 ppm and without combustion noise (less than 0.15% peak to peak).
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.