No abstract

Photodarkening is recognized as a potentially important limiting factor on the lifetime and reliability of many Yb-doped fiber lasers and amplifiers. In particular, a photodarkening process attributed to the formation of photoinduced structural transformations can induce excess loss in the doped glass core of the fiber, resulting in reduced output power efficiency. Yet, quantifiable measurement techniques of this phenomenon have been scarce in the literature to date. Here we present a fast, simple and repeatable method to measure and compare the photodarkening rate caused by the formation of photoinduced structural transformations from Yb-doped single-mode fibers. The method relies on quantifying observations of transmission changes at visible wavelengths as an indicative measure of photodarkening at the signal wavelengths. Preliminary measurement results are presented supporting the utility of the technique for benchmarking the photodarkening behavior of different Yb-doped fibers.

Conversion efficiencies in excess of 50% have been measured in frequency-doubling experiments in KTP using divergent fundamental 1.064-,um beams. Various doubling schemes have been investigated to avoid reconversion effects observed in 9-mm-long crystals. The phase-matching angular acceptance bandwidth, damage-threshold observations, and a measurement of effective susceptibility relative to KD*P are also reported.

Yb-doped fibers are widely used in laser applications requiring high average output powers and high-peak-power pulse amplification. Photodarkening (PD) is recognized as one limiting factor in these fibers when pumped with high-intensity radiation. We describe an approach for performing quantitative PD studies of fibers, and we present measurements of the rate of PD in Yb-doped single-mode fibers with varying inversion levels. The method is applicable to large-mode-area fibers. We observed a seventh-order dependence of the PD rate on the excited-state Yb concentration for two different fibers; this result implies that PD of a Yb-doped fiber source fabricated using a particular fiber will be strongly dependent on the configuration of the device.

No abstract