[1] A multitude of sensitivity studies in the literature point to the importance of proper chemical and morphological characterization of particles when the radiative impacts of airborne dusts are modeled. However, the community data set is based on heterogeneous measurement methods relying on varying aerodynamic, chemical, morphological, and optical means. During the Puerto Rico Dust Experiment, size distributions of dust particles from Africa were measured using a variety of aerodynamic, optical, and geometric means. Consistent with the literature, comparisons of these size distributions showed quite dissimilar results. ''Measured'' volume median diameters varied from 2.5 to 9 mm for various geometric, aerodynamic, optical, and optical inversion methods. Aerodynamic systems showed mixed performance. Column integrated size distributions inverted from AERONET Sun/sky radiance data produced somewhat reasonable results in the coarse mode when given proper constraints and taken in the proper context. The largest systematic errors were found in optical particle counters due to insensitivities to particle size in the 4-10 mm region with further complications due to dust particle morphology and index of refraction issues. As these methods can produce quite dissimilar size distributions, considerable errors in calculated radiative properties can occur if incorrectly modeled into dust parameters. None of the methods compared in this study can adequately reproduce the measured mass extinction or mass scattering efficiency of the dust using spherical geometry methods. Given all of the uncertainties in the sizing methods, we promote the use of fundamental and quantifiable descriptors of particles such as mass as a function of aerodynamic diameter.

[1] Values for Mie-equivalent aerosol asymmetry parameter (g) were derived using a variety of methods from the large suite of measurements (in situ and remote from surface and aircraft) made in Oklahoma during the 2003 aerosol Intensive Operations Period (IOP). Median values derived for dry asymmetry parameter at 550 nm ranged between 0.55 and 0.63 over all instruments and for all derivation methods, with the exception of one instrument which did not measure over the full size range of optically important aerosol. Median values for the ''wet'' asymmetry parameter (i.e., asymmetry parameter at humidity conditions closer to ambient) were between 0.59 and 0.72. Values for g derived for surface and airborne in situ measurements were highly correlated, but in situ and remote sensing measurements both at the surface and aloft did not agree as well because of vertical inhomogeneity of the aerosol. Radiative forcing calculations suggest that a 10% decrease in g would result in a 19% reduction in top of atmosphere radiative forcing for the conditions observed during the IOP. Comparison of the different methods for deriving g suggests that in computing the asymmetry parameter, aerosol size is the most important parameter to measure; composition is less important except for how it influences the hygroscopic growth (i.e., size) of particles.

, with an average of 0.172 mg m À3 . Lower concentrations were measured in the Basin outflow regions and above the inversion layer. The SP2 afforded a quantification of the mixing state of rBC aerosols through modeling the scattering cross-section with a core-and-shell Mie model to determine coating thickness. The rBC particles above the inversion layer were more thickly coated by a light-scattering substance than those below, indicating a more aged aerosol in the free troposphere. Near the surface, as the LA plume is advected from west to east with the sea breeze, a coating of scattering material grows on rBC particles, coincident with a clear growth of ammonium nitrate within the LA Basin and the persistence of water-soluble organic compounds as the plume travels through the outflow regions. Detailed analysis of the rBC mixing state reveals two modes of coated rBC particles; a mode with smaller rBC core diameters ($90 nm) but thick (>200 nm) coating diameters and a mode with larger rBC cores ($145 nm) with a thin (<75 nm) coating. The "weekend effect" in the LA Basin results in more thickly coated rBC particles, coinciding with more secondary formation of aerosol.

During the 2011 Eastern Pacific Emitted Aerosol Cloud Experiment (E‐PEACE) and 2013 Nucleation in California Experiment (NiCE) field campaigns, a predominantly organic aerosol (> 85% by mass) was observed in the free troposphere over marine stratocumulus off the coast of California. These particles originated from a densely forested region in the Northwestern United States. The organic mass spectrum resolved by positive matrix factorization is consistent with the mass spectra of previously measured biogenic organic aerosol. Particulate organic mass exhibits a latitudinal gradient that corresponds to the geographical distribution of vegetation density and composition, with the highest concentration over regions impacted by densely populated monoterpene sources. Due to meteorological conditions during summer months, cloud‐clearing events transport aerosol from the Northwestern United States into the free troposphere above marine stratocumulus. Based on the variation of meteorological variables with altitude, dry air containing enhanced biogenic organic aerosol is shown to entrain into the marine boundary layer. Fresh impacts on cloud water composition are observed north of San Francisco, CA which is consistent with fresh continental impacts on the marine atmosphere at higher latitudes. Continental aerosol size distributions are bimodal. Particles in the 100 nm mode are impacted by biogenic sources, while particles in the ∼ 30 nm mode may originate from fresh biogenic emissions. Continental aerosol in the 100 nm mode is cloud condensation nuclei active and may play a role in modulating marine stratocumulus microphysics.

Abstract. The performance of the Weather Research and Forecasting regional model with chemistry (WRF-Chem) in simulating the spatial and temporal variations in aerosol mass, composition, and size over California is quantified using the extensive meteorological, trace gas, and aerosol measurements collected during the California Nexus of Air Quality and Climate Experiment (CalNex) and the Carbonaceous Aerosol and Radiative Effects Study (CARES) conducted during May and June of 2010. The overall objective of the field campaigns was to obtain data needed to better understand processes that affect both climate and air quality, including emission assessments, transport and chemical aging of aerosols, aerosol radiative effects. Simulations were performed that examined the sensitivity of aerosol concentrations to anthropogenic emissions and to long-range transport of aerosols into the domain obtained from a global model. The configuration of WRF-Chem used in this study is shown to reproduce the overall synoptic conditions, thermally driven circulations, and boundary layer structure observed in region that controls the transport and mixing of trace gases and aerosols. Reducing the default emissions inventory by 50% led to an overall improvement in many simulated trace gases and black carbon aerosol at most sites and along most aircraft flight paths; however, simulated organic aerosol was closer to observed when there were no adjustments to the primary organic aerosol emissions. We found that sulfate was better simulated over northern California whereas nitrate was better simulated over southern California. While the overall spatial and temporal variability of aerosols and their precursors were simulated reasonably well, we show cases where the local transport of some aerosol plumes were either too slow or too fast, which adversely affects the statistics quantifying the differences between observed and simulated quantities. Comparisons with lidar and in situ measurements indicate that long-range transport of aerosols from the global model was likely too high in the free troposphere even though their concentrations were relatively low. This bias led to an over-prediction in aerosol optical depth by as much as a factor of 2 that offset the under-predictions of boundary-layer extinction resulting primarily from local emissions. Lowering the boundary conditions of aerosol concentrations by 50% greatly reduced the bias in simulated aerosol optical depth for all regions of California. This study shows that quantifying regional-scale variations in aerosol radiative forcing and determining the relative role of emissions from local and distant sources is challenging during `clean' conditions and that a wide array of measurements are needed to ensure model predictions are correct for the right reasons. In this regard, the combined CalNex and CARES data sets are an ideal test bed that can be used to evaluate aerosol models in great detail and develop improved treatments for aerosol processes.