No abstract

Recently fluid flow has been shown to be a potent physical stimulus in the regulation of bone cell metabolism. However, most investigators have applied steady or pulsing flow profiles rather than oscillatory fluid flow, which occurs in vivo because of mechanical loading. Here oscillatory fluid flow was demonstrated to be a potentially important physical signal for loading-induced changes in bone cell metabolism. We selected three well known biological response variables including intracellular calcium (Ca

Bone is removed or replaced in defined locations by targeting osteoclasts and osteoblasts in response to its local history of mechanical loading. There is increasing evidence that osteocytes modulate this targeting by their apoptosis, which is associated with locally increased bone resorption. To investigate the role of osteocytes in the control of loading-related modeling or remodeling, we studied the effects on osteocyte viability of short periods of mechanical loading applied to the ulnae of rats. Loading, which produced peak compressive strains of -0.003 or -0.004, was associated with a 78% reduction in the resorption surface at the midshaft. The same loading regimen resulted in a 40% relative reduction in osteocyte apoptosis at the same site 3 days after loading compared with the contralateral side (P = 0.01). The proportion of osteocytes that were apoptotic was inversely related to the estimated local strain (P < 0.02). In contrast, a single short period of loading resulting in strains of -0.008 engendered both tissue microdamage and subsequent bone remodeling and was associated with an eightfold increase in the proportion of apoptotic osteocytes (P = 0.02) at 7 days. This increase in osteocyte apoptosis was transient and preceded both intracortical remodeling and death of half of the osteocytes (P < 0.01). The data suggest that osteocytes might use their U-shaped survival response to strain as a mechanism to influence bone remodeling. We hypothesize that this relationship reflects a causal mechanism by which osteocyte apoptosis regulates bone's structural architecture.

This review describes the role of bone cells and their surrounding matrix in maintaining bone strength through the process of bone remodeling. Subsequently, this work focusses on how bone formation is guided by mechanical forces and fluid shear stress in particular. It has been demonstrated that mechanical stimulation is an important regulator of bone metabolism. Shear stress generated by interstitial fluid flow in the lacunar-canalicular network influences maintenance and healing of bone tissue. Fluid flow is primarily caused by compressive loading of bone as a result of physical activity. Changes in loading, e.g., due to extended periods of bed rest or microgravity in space are associated with altered bone remodeling and formation in vivo. In vitro, it has been reported that bone cells respond to fluid shear stress by releasing osteogenic signaling factors, such as nitric oxide, and prostaglandins. This work focusses on the application of in vitro models to study the effects of fluid flow on bone cell signaling, collagen deposition, and matrix mineralization. Particular attention is given to in vitro set-ups, which allow long-term cell culture and the application of low fluid shear stress. In addition, this review explores what mechanisms influence the orientation of collagen fibers, which determine the anisotropic properties of bone. A better understanding of these mechanisms could facilitate the design of improved tissue-engineered bone implants or more effective bone disease models.

Allogeneic bone grafts are frequently sterilized by means of ionizing radiation. We investigated the effects of ionizing radiation on both quasistatic and impact mechanical properties of human bone. Specimens from four paired femora of four donors received doses of 29.5 kGy ("standard," frequently used by tissue banks), 94.7 kGy ("high"), or 17 kGy ("low") of ionizing radiation. Young's modulus was unchanged by any level of radiation. Radiation significantly reduced bending strength, work to fracture, and impact energy absorption; in each case, the severity of the effect increased from low to standard to high doses of radiation. Work to fracture was particularly severely degraded; specimens irradiated with the high dose absorbed only 5% of the energy of the controls. Radiation, even at relatively low doses, makes the bone more brittle and thereby reduces its energy-absorbing capacity. We suggest that because the level of radiation required to produce an acceptable level of viral inactivation (90 kGy) produces an unacceptable reduction in the mechanical integrity of the bone, low levels of radiation, sufficient to produce bacterial safety, should be used in conjunction with biological tests to ensure viral safety.

Aim To determine whether fluid flow-induced shear stress affects the differentiation of bone marrow-derived human mesenchymal stem cells (hMSCs) into osteogenic cells. Materials & methods hMSCs cultured with or without osteogenic differentiation medium were exposed to fluid flow-induced shear stress and analyzed for alkaline phosphatase activity and expression of osteogenic genes. Results Immediately following shear stress, alkaline phosphatase activity in osteogenic medium was significantly increased. At days 4 and 8 of culture the mRNA expression of bone morphogenetic protein-2 and osteopontin was significantly higher in hMSCs subjected to shear stress than those cultured in static conditions. However, hMSCs cultured in osteogenic differentiation medium were less responsive in gene expression of alkaline phosphatase and bone morphogenetic protein-2. Conclusion These data demonstrate that shear stress stimulates hMSCs towards an osteoblastic phenotype in the absence of chemical induction, suggesting that certain mechanical stresses may serve as an alternative to chemical stimulation of stem cell differentiation.

Bioactive glass is used as both a bone filler and as a coating on implants, and has been advocated as a potential osteogenic scaffold for tissue engineering. Rat-derived mesenchymal stem cells (MSCs) show elevated levels of alkaline phosphatase activity when grown on 45S5 bioactive glass as compared to standard tissue culture plastic. Similarly, exposure to the dissolution products of 45S5 elevates alkaline phosphatase activity and other osteogenic markers in these cells. We investigated whether human MSCs grown under the same laboratory conditions as rat MSCs would exhibit similar responses. In general, human MSCs produce markedly less alkaline phosphatase activity than rat MSCs, regardless of cell culture conditions, and do not respond to the growth factor BMP-2 in the same way as rat MSCs. In our experiments there was no difference in alkaline phosphatase activity between human MSCs grown on 45S5 bioactive glass or tissue culture plastic, in samples from five different orthopaedic patients, regardless of culture media composition. Neither was there any consistent effect of 45S5 dissolution products on human MSCs from three different donors. These results suggest that the positive effects of bioactive glass on bone growth in human patients are not mediated by accelerated differentiation of mesenchymal stem cells.

Polymerized high internal phase emulsion (polyHIPE) foams are extremely versatile materials for investigating cell-substrate interactions in vitro. Foam morphologies can be controlled by polymerization conditions to result in either open or closed pore structures with different levels of connectivity, consequently enabling the comparison between 2D and 3D matrices using the same substrate with identical surface chemistry conditions. Additionally, here we achieve the control of pore surface topology (i.e. how different ligands are clustered together) using amphiphilic block copolymers as emulsion stabilisers. We demonstrate that adhesion of human mesenchymal progenitor (hES-MP) cells cultured on polyHIPE foams is dependent on foam surface topology and chemistry but is independent of porosity and interconnectivity. We also demonstrate that the interconnectivity, architecture and surface topology of the foams has an effect on the osteogenic differentiation potential of hES-MP cells. Together these data demonstrate that the adhesive heterogeneity of a 3D scaffold could regulate not only mesenchymal stem cell attachment but also cell behavior in the absence of soluble growth factors.