No abstract

No abstract

Both magmatic and tectonic processes contribute to the formation of volcanic continental margins. Such margins are thought to undergo extension across a narrow zone of lithospheric thinning (~100 km). New observations based on existing and reprocessed data from the Eastern North American Margin contradict this hypothesis. With~64,000 km of 2-D seismic data tied to 40 wells combined with published refraction, deep reflection, receiver function, and onshore drilling efforts, we quantified along-strike variations in the distribution of rift structures, magmatism, crustal thickness, and early post-rift sedimentation under the shelf of Baltimore Canyon Trough (BCT), Long Island Platform, and Georges Bank Basin (GBB). Results indicate that BCT is narrow (80-120 km) with a sharp basement hinge and few rift basins. The seaward dipping reflectors (SDR) there extend~50 km seaward of the hinge line. In contrast, the GBB is wide (~200 km), has many syn-rift structures, and the SDR there extend~200 km seaward of the hinge line. Early post-rift depocenters at the GBB coincide with thinner crust suggesting "uniform" thinning of the entire lithosphere. Models for the formation of volcanic margins do not explain the wide structure of the GBB. We argue that crustal thinning of the BCT was closely associated with late syn-rift magmatism, whereas the broad thinning of the GBB segment predated magmatism. Correlation of these variations to crustal terranes of different compositions suggests that the inherited rheology determined the premagmatic response of the lithosphere to extension.

No abstract

No abstract

The Dead Sea is an extensional basin developing along a transform fault plate boundary. It is also a terminal salt basin. Without knowledge of precise stratigraphy, it is difficult to differentiate between the role of plate and salt tectonics on sedimentary accumulation and deformation patterns. While the environmental conditions responsible for sediment supply are reasonably constrained by previous studies on the lake margins, the current study focuses on deciphering the detailed stratigraphy across the entire northern Dead Sea basin as well as syn and post‐depositional processes. The sedimentary architecture of the late Quaternary lacustrine succession was examined by integrating 851 km of seismic reflection data from three surveys with gamma ray and velocity logs and the stratigraphic division from an ICDP borehole cored in 2010. This allowed seismic interpretation to be anchored in time across the entire basin. Key surfaces were mapped based on borehole lithology and a newly constructed synthetic seismogram. Average interval velocities were used to calculate isopach maps and spatial and temporal sedimentation rates. Results show that the Amora Formation was deposited in a pre‐existing graben bounded by two N‐S trending longitudinal faults. Both faults remained active during deposition of the late Pleistocene Samra and Lisan Formations—the eastern fault continued to bound the basin while the western fault remained blind. On‐going plate motion introduced a third longitudinal fault, increasing accommodation space westwards from the onset of deposition of the Samra Formation. During accumulation of these two formations, sedimentation rates were uniform over the lake and similar. High lake levels caused an increase in hydrostatic pressure. This led to salt withdrawal, which flowed to the south and southwest causing increased uplift of the Lisan and En Gedi diapirs and the formation of localized salt rim synclines. This induced local seismicity and slumping, resulting in an increased thickness of the Lisan succession within the lake relative to its margins. Sedimentation rates of the Holocene Ze'elim Fm were 4–5 times higher than before. The analysis presented here resolves central questions of spatial extent and timing of lithology, deposition rates and their variability across the basin, timing of faulting at and below the lake floor, and timing and extent of salt and plate tectonic phases and their effect on syn and post‐depositional processes. Plate tectonics dictated the structure of the basin, while salt tectonics and sediment accumulation were primarily responsible for its fill architecture during the timeframe examined here.

Seafloor geoacoustic properties are important in determining sound propagation in the marine environment, which broadly affects sub-sea activities. However, geoacoustic investigation of the deep seafloor, which is required by the recent expansion of deep-water operations, is challenging. This paper presents a methodology for estimating the seafloor sound speed, c0, and a sub-bottom velocity gradient, K, in a relatively deep-water-compacting (~1000 m) passive-margin setting, based on standard commercial 2D seismic data. Here we study the seafloor of the southeastern Mediterranean margin based on data from three commercial seismic profiles, which were acquired using a 7.2 km-long horizontal receiver array. The estimation applies a geoacoustic inversion of the wide-angle reflections and the travel times of the head waves of bending rays. Under the assumption of a constant positive K, the geoacoustic inversion converges to a unique set of parameters that best satisfy the data. The analysis of 24 measurement locations revealed an increase in the average estimates of c0 from 1537 ± 13 m s−1 to 1613 ± 12 m s−1 for seafloor depths between ~1150 m and ~1350 m. K ranged between 0.75 and 0.85 m s−1 with an average of 0.80 ± 0.035 s−1. The parameters were consistent across the different locations and seismic lines and they match the values that were obtained through depth-migration-velocity analysis and empiric relations, thereby validating our estimation methodology.

Both magmatic and tectonic processes contribute to the formation of volcanic continental margins. Such margins are thought to undergo extension across a narrow zone of lithospheric thinning (~100 km). New observations based on existing and reprocessed data from the Eastern North American Margin contradict this hypothesis. With~64,000 km of 2-D seismic data tied to 40 wells combined with published refraction, deep reflection, receiver function, and onshore drilling efforts, we quantified along-strike variations in the distribution of rift structures, magmatism, crustal thickness, and early post-rift sedimentation under the shelf of Baltimore Canyon Trough (BCT), Long Island Platform, and Georges Bank Basin (GBB). Results indicate that BCT is narrow (80-120 km) with a sharp basement hinge and few rift basins. The seaward dipping reflectors (SDR) there extend~50 km seaward of the hinge line. In contrast, the GBB is wide (~200 km), has many syn-rift structures, and the SDR there extend~200 km seaward of the hinge line. Early post-rift depocenters at the GBB coincide with thinner crust suggesting "uniform" thinning of the entire lithosphere. Models for the formation of volcanic margins do not explain the wide structure of the GBB. We argue that crustal thinning of the BCT was closely associated with late syn-rift magmatism, whereas the broad thinning of the GBB segment predated magmatism. Correlation of these variations to crustal terranes of different compositions suggests that the inherited rheology determined the premagmatic response of the lithosphere to extension.