Titania loaded with noble metal nanoparticles exhibits enhanced photocatalytic killing of bacteria under light illumination due to the localized surface plasmon resonance (LSPR) property. It has been shown recently that loading with Au or Ag can also endow TiO2 with the antibacterial ability in the absence of light. In this work, the antibacterial mechanism of Au-loaded TiO2 nanotubes (Au@TiO2-NT) in the dark environment is studied, and a novel type of extracellular electron transfer (EET) between the bacteria and the surface of the materials is observed to cause bacteria death. Although the EET-induced bacteria current is similar to the LSPR-related photocurrent, the former takes place without light, and no reactive oxygen species (ROS) are produced during the process. The EET is also different from that commonly attributed to microbial fuel cells (MFC) because it is dominated mainly by the materials' surface, but not the bacteria, and the environment is aerobic. EET on the Au@TiO2-NT surface kills Staphylococcus aureus, but if it is combined with special MFC bacteria, the efficiency of MFC may be improved significantly.
Many
postsurgical complications stem from bacteria colony formation
on the surface of implants, but the usage of antibiotic agents may
cause antimicrobial resistance. Therefore, there is a strong demand
for biocompatible materials with an intrinsic antibacterial resistance
not requiring extraneous chemical agents. In this study, homogeneous
nanocones were fabricated by oxygen plasma etching on the surface
of natural, biocompatible Bombyx mori silk films. The new hydroxyl
bonds formed on the surface of the nanopatterned film by plasma etching
increased the surface energy by around 176%. This hydrophilic nanostructure
reduced the bacterial attachment by more than 90% for both Gram-negative
(Escherichia coli) and Gram-positive
(Staphylococcus aureus) bacteria and
at the same time improved the proliferation of osteoblast cells by
30%. The nanoengineered substrate and pristine silk were cultured
for 6 h with three different bacteria concentrations of 107, 105, and 103 CFU mL–1 and
the cell proliferation on the nanopatterned samples was significantly
higher due to limited bacteria attachment and prevention of biofilm
formation. The concept and materials described here reveal a promising
alternative to produce biomaterials with an inherent biocompatibility
and bacterial resistance simultaneously to mitigate postsurgical infections
and minimize the use of antibiotics.
Magnesium-based materials are preferred in temporary orthopedic implants because of their biodegradability, mechanical properties, and intrinsic antibacterial properties. However, the fundamental mechanism of bacteria killing and roles of various factors are not clearly understood. In this study, we performed a systematic study of the antibacterial properties of two common Mg-based materials using a biofilm forming bacterium. Complete annihilation of the initial 3 × 10(4) bacteria is achieved with both materials in 0.1 mL LB medium in 24 h, whereas in the control, they proliferate to 10(10). The bacteria are killed more effectively in the solution than on the surface, and the bacteria killing efficiency depends more on the concentrations of the magnesium ions and hydroxyl ions than the corrosion rate. The killing process is reproduced using formula solutions, and killing is revealed to stem from the synergetic effects of alkalinity and magnesium ions instead of either one of them or Mg(OH)2 precipitate. Reactive oxygen species (ROS) are detected from the bacteria during the killing process but are not likely produced by the redox reaction directly, because they are detected at least 3 h after the reaction has commenced. The average cell size increases during the killing process, suggesting that the bacteria have difficulty with normal division which also contributes to the reduced bacteria population.
MoSe 2 is an efficient catalyst for the hydrogen evolution reaction (HER) and can potentially replace conventional catalysts composed of noble metals such as Pt. The HER activity of MoSe 2 originates mainly from the edge sites of Se atoms, but the low concentration of Se exposed to the electrolyte hampers the performance. Hence, activating a larger portion of the basal plane of Se atoms is an effective way to improve the HER properties. Herein, a 3D hierarchic nanoflower structure comprising MoSe 2 with atomic-scale interlayered graphene layers in the nanosheets is designed and prepared to improve the electron conductivity and decrease the proportions of inactive basal planes. Raman scattering, transmission electron microscopy, and energy-dispersive X-ray spectroscopy verify effective insertion of graphene layers in MoSe 2 , and the HER characteristics are improved as exemplified by a small overpotential of 175 mV at 10 mA cm −2 , small Tafel slope of 58 mV dec −1 , and excellent durability with only small deterioration of 10 mV after 10,000 cycles. First-principles density functional theory and finite element method calculations corroborate the experimental results, revealing better conductivity and hydrogen adsorption/desorption ability rendered by the graphene layers. Our results reveal a new and effective strategy to optimize the structure and composition and reduce the hydrogen adsorption energy barrier in the pursuit of high-efficiency non-noble metal catalysts.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.