The effects of Ni on the properties of the Sn-2.5Ag-0.7Cu-0.1Re solder alloy and its creep properties of solder joints are researched. The results show that with adding 0.05wt% Ni in the Sn-2.5Ag-0.7Cu-0.1Re solder alloy, the elongation can be sharply improved without decreasing its tensile strength and it is 1.4 times higher than that of the commercial Sn-3.8Ag-0.7Cu solder alloy. Accordingly the creep rupture life of Sn-2.5Ag-0.7Cu-0.1Re-0.05Ni solder joints is the longest, which is 13.3 times longer than that of Sn-2.5Ag-0.7Cu-0.1Re and is also longer than that of the commercial Sn-3.8Ag-0.7Cu solder alloy. In the same environmental conditions, the creep rupture life of Sn-2.5Ag-0.7Cu-0.1Re-0.05Ni solder joints can sharply decrease with increasing the temperature and stress.
Effect of rare earth content on microstructure and interfacial reactions of low Ag content SnAgCu solder is researched by adopting the X-ray diffraction, JSM-5610LV scanning electronic microscope, energy spectrum analysis and JEM2100 ultrahigh resolution electron microscopy. The results show that proper quantities of rare earth (0.1%) can refine the eutectic microstructure of the solder alloy; and petal-like rare earth compound can be found in the solder alloy while the rare earth addition is 0.5%. The growing rate of the interfacial intermetallic compound can be reduced during the soldering with adding 0.1% rare earth in the Sn2.5Ag0.7Cu solder alloy.
Numerical simulation and deposited experiment of MAG welding are carried out on the conditions of Electro-Magnetic Stirring (EMS) in this paper. Based on the research of EMS welding arc action, a simple EMS-MAG welding Gaussian distribution model using whole heat flux density is established, which MAG welding arc and droplet transfer are regarded as one integrated system. The important additional magnetic field parameter in EMS-MAG surfacing deposited welding is considered in this model. The computer-aided arc measurement system is used to analyze the effects of additional magnetic field in MAG welding. Effects of excitation current on welding penetration and width are analyzed by deposited experiments. Many deposited experiments are used to adjust model parameters and verify the simulation results. By defining key parameter and optimizing the model on the basis of experimental data, it can improve the simulation accuracy effectively. The results show that the established Gaussian distribution model can be used to simulate EMS-MAG welding process.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.